Verification of the Measurement System in a Production Organization
Miroslav Prístavka
Institute of Design and Engineering Technologies, Slovak University of Agriculture in NitraSlovakia
Profilo OrcidCerca questo autore su
, Pavol Findura
Institute of Agricultural Engineering, Transport and Bioenergetics, Slovak University of Agriculture in NitraSlovakia
Profilo OrcidCerca questo autore su
, Ivan Beloev
Department of Transport, Faculty of Transport, University of RuseRuse, Bulgaria
Profilo OrcidCerca questo autore su
, Maciej Kuboń
- Department of Production Engineering, Logistics and Applied Computer Science, Faculty of Production and Power Engineering, University of Agriculture in KrakówPoland
- Eastern European State College of Higher Education in PrzemyślPoland
Profilo OrcidCerca questo autore su
, Veronika Hrdá
Institute of Economics and Management, Slovak University of Agriculture in NitraNitra, Slovakia
Profilo OrcidCerca questo autore su
, e 06 giu 2022
INFORMAZIONI SU QUESTO ARTICOLO
Pubblicato online: 06 giu 2022
Pagine: 81 - 90
Ricevuto: 01 mar 2022
Accettato: 01 mag 2022
DOI: https://doi.org/10.2478/agriceng-2022-0007
Parole chiave
© 2022 Miroslav Prístavka et al., published by Sciendo
This work is licensed under the Creative Commons Attribution 4.0 International License.
Monitoring the accuracy of meters by qualified workers and managers is a preventive measure of every organization. The paper focuses on monitoring the accuracy of measuring devices and proposes preventive and corrective actions. The discussed measurement device was tested for accuracy using accuracy indexes Cg and Cgk. The identified deviations in measurements showed that the meter was not fully efficient. Consequently, actions were taken to ensuring that the measurement device is accurate.