<abstract xmlns="http://www.w3.org/1999/xhtml"><p>Measurements of Residual Magnetic Field RMF (the tangential component parallel to the load direction) were taken on the surface of P91 steel plate samples (X10CrMoVNb9-1) subjected to periodic pulsating tensile cyclic loads with the use of flux-gate and magneto impedance sensors, and preliminary measurement results are compiled and analyzed. The study investigates how the microstructure and load cycle parameters affect the RMF changes due to stress variations. Each combination of parameters: microstructure and load cycle corresponds to the characteristic variability pattern of magnetization and its maximum and minimum values.</p></abstract>

Measurements of Residual Magnetic Field RMF (the tangential component parallel to the load direction) were taken on the surface of P91 steel plate samples (X10CrMoVNb9-1) subjected to periodic pulsating tensile cyclic loads with the use of flux-gate and magneto impedance sensors, and preliminary measurement results are compiled and analyzed. The study investigates how the microstructure and load cycle parameters affect the RMF changes due to stress variations. Each combination of parameters: microstructure and load cycle corresponds to the characteristic variability pattern of magnetization and its maximum and minimum values.

The Influence of Pulsating Tensile Stress on Residual Magnetic Field of P91 Steel Samples

Department of Machine Engineering and Transport

Advances in Materials Science

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Measurements of Residual Magnetic Field RMF (the tangential component parallel to the load direction) were taken on the surface of P91 steel plate samples...

The Influence of Pulsating Tensile Stress on Residual Magnetic Field of P91 Steel Samples

Pubblicato online: 02 lug 2019

Pagine: 72 - 82

DOI: https://doi.org/10.2478/adms-2019-0012

Parole chiave
P91 steel, residual magnetic field, magnetization, measurement, microstructure

© 2019 A. Złocki et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

The Influence of Pulsating Tensile Stress on Residual Magnetic Field of P91 Steel Samples

Pubblicato online: 02 lug 2019

Pagine: 72 - 82

DOI: https://doi.org/10.2478/adms-2019-0012

Parole chiaveP91 steel, residual magnetic field, magnetization, measurement, microstructure

© 2019 A. Złocki et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Parole chiave
P91 steel, residual magnetic field, magnetization, measurement, microstructure