<abstract xmlns="http://www.w3.org/1999/xhtml"><p>This paper deals with hard turning using a cutting tool with Xcel geometry. This is one of the new geometries, and there is not any information about Xcel wear in comparison to the conventional geometry. It is already known from cutting tools producers that using the Xcel geometry leads to higher quality of machined surface, perticularly surface roughness. It is possible to achieve more than 4 times lower Ra and Rz values after turning than after using conventional geometry with radius. The workpiece material was 100Cr6 hardened steel with hardness of 60 ± 1 HRC. The machine used for the experiment was a lathe with counter spindle DMG CTX alpha 500, which is located in the Centre of Excellence of 5–axis Machining at the Faculty of Materials Science and Technology in Trnava. The cutting tools made by CBN were obtained from Sandvik COROMANT Company.</p><p>The aim of this paper is to investigate the cutting tool wear in hard turning process by the Xcel cutting tool geometry.</p></abstract>

This paper deals with hard turning using a cutting tool with Xcel geometry. This is one of the new geometries, and there is not any information about Xcel wear in comparison to the conventional geometry. It is already known from cutting tools producers that using the Xcel geometry leads to higher quality of machined surface, perticularly surface roughness. It is possible to achieve more than 4 times lower Ra and Rz values after turning than after using conventional geometry with radius. The workpiece material was 100Cr6 hardened steel with hardness of 60 ± 1 HRC. The machine used for the experiment was a lathe with counter spindle DMG CTX alpha 500, which is located in the Centre of Excellence of 5–axis Machining at the Faculty of Materials Science and Technology in Trnava. The cutting tools made by CBN were obtained from Sandvik COROMANT Company.The aim of this paper is to investigate the cutting tool wear in hard turning process by the Xcel cutting tool geometry.

Wear of Cutting Tool with Excel Geometry in Turning Process of Hardened Steel

Institute of Production Technologies, Faculty of Materials Science and Technology in Trnava, Slovak University of Technology in Bratislava, Ulica Jána Bottu 2781/25, 917 24 Trnava, Slovak Republic

Research Papers Faculty of Materials Science and Technology Slovak University of Technology

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

{"article-title":"Wear of Cutting Tool with Excel Geometry in Turning Process of Hardened Steel"}

This paper deals with hard turning using a cutting tool with Xcel geometry. This is one of the new geometries, and there is not any information about Xcel wear...

Wear of Cutting Tool with Excel Geometry in Turning Process of Hardened Steel

Pubblicato online: 04 apr 2017

Pagine: 95 - 102

DOI: https://doi.org/10.1515/rput-2016-0044

Parole chiave
Hard turning, Xcel geometry, conventional geometry, cutting tool wear

© 2016 Michaela Samardžiová, published by De Gruyter Open

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Wear of Cutting Tool with Excel Geometry in Turning Process of Hardened Steel

Pubblicato online: 04 apr 2017

Pagine: 95 - 102

DOI: https://doi.org/10.1515/rput-2016-0044

Parole chiaveHard turning, Xcel geometry, conventional geometry, cutting tool wear

© 2016 Michaela Samardžiová, published by De Gruyter Open

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Parole chiave
Hard turning, Xcel geometry, conventional geometry, cutting tool wear