<abstract xmlns="http://www.w3.org/1999/xhtml"><p>The issues of cutting environment and a suitable choice of cutting conditions by drilling are the main subjects of the article. Attention is paid to the application of the drilling process into the carbon steel. Analysed were the phenomena that adversely affect the tool life. The article demonstrated solutions how to remove these adverse effects. The multicriteria optimisation of input factors (cutting fluid concentration, cutting speed) for a defined target function (tool life) was applied. The measured values were subjected to mathematical–statistical analysis (ANOVA). Based on the implemented experiment and study of this issue, we determined the combinations of input factors, which achieved minimal values of target functions. Based on the implemented experiment and study of this issue, we also determined the combinations of input factors, which achieved minimal values of target functions. Based on this allegation, the most appropriate combination of the following input factors was proved: concentration 6.3 % and cutting speed 100 m/min.</p></abstract>

The issues of cutting environment and a suitable choice of cutting conditions by drilling are the main subjects of the article. Attention is paid to the application of the drilling process into the carbon steel. Analysed were the phenomena that adversely affect the tool life. The article demonstrated solutions how to remove these adverse effects. The multicriteria optimisation of input factors (cutting fluid concentration, cutting speed) for a defined target function (tool life) was applied. The measured values were subjected to mathematical–statistical analysis (ANOVA). Based on the implemented experiment and study of this issue, we determined the combinations of input factors, which achieved minimal values of target functions. Based on the implemented experiment and study of this issue, we also determined the combinations of input factors, which achieved minimal values of target functions. Based on this allegation, the most appropriate combination of the following input factors was proved: concentration 6.3 % and cutting speed 100 m/min.

Influence of Cutting Environment on Tool Life

Institute of Production Technologies, Faculty of Materials Science and Technology in Trnava, Slovak University of Technology in Bratislava, Ulica Jána Bottu 2781/25, 917 24 Trnava, Slovak Republic

Institute of Integrated Safety, Faculty of Materials Science and Technology in Trnava, Slovak University of Technology in Bratislava, Ulica Jána Bottu 2781/25, 917 24 Trnava, Slovak Republic

Research Papers Faculty of Materials Science and Technology Slovak University of Technology

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

{"article-title":"Influence of Cutting Environment on Tool Life"}

The issues of cutting environment and a suitable choice of cutting conditions by drilling are the main subjects of the article. Attention is paid to the...

Influence of Cutting Environment on Tool Life

Pubblicato online: 04 apr 2017

Pagine: 9 - 15

DOI: https://doi.org/10.1515/rput-2016-0033

Parole chiave
cutting fluids, cutting speed, drilling, tool life, ANOVA

© 2016 Eva Buranská et al., published by De Gruyter Open

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Influence of Cutting Environment on Tool Life

Pubblicato online: 04 apr 2017

Pagine: 9 - 15

DOI: https://doi.org/10.1515/rput-2016-0033

Parole chiavecutting fluids, cutting speed, drilling, tool life, ANOVA

© 2016 Eva Buranská et al., published by De Gruyter Open

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Parole chiave
cutting fluids, cutting speed, drilling, tool life, ANOVA