<abstract xmlns="http://www.w3.org/1999/xhtml"><p> Welding proces is basic joining technique in shipbuilding. Such method generated welding distortions which cause a lot of problems during the manufacturing process. In the literature it is proposed wide spectrum of suggestions for a correct estimation of welding deformation in particular angular deformation in the fillet welded T joint. In the work influence of oversizing of weld on angular distortions of joint is presented basing upon of the results of the laboratory measurements. Values determined on the basis of literature hypotheses are compared with the one obtained from the laboratory test.</p></abstract>

Welding proces is basic joining technique in shipbuilding. Such method generated welding distortions which cause a lot of problems during the manufacturing process. In the literature it is proposed wide spectrum of suggestions for a correct estimation of welding deformation in particular angular deformation in the fillet welded T joint. In the work influence of oversizing of weld on angular distortions of joint is presented basing upon of the results of the laboratory measurements. Values determined on the basis of literature hypotheses are compared with the one obtained from the laboratory test.

The Influence of Manufacturing Oversizing on Postwelding Distortions of the Fillet Welded Joint

Gdansk University of Technology Faculty of Ocean Engineering and Ship Technology Naurutowicza 11/12 St. 80-233 Gdansk, Poland phone: +48 58 3471735

Gdansk University of Technology Faculty of Ocean Engineering and Ship Technology Naurutowicza 11/12 St. 80-233 Gdansk, Poland

Polish Maritime Research

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

Welding proces is basic joining technique in shipbuilding. Such method generated welding distortions which cause a lot of problems during the manufacturing...

The Influence of Manufacturing Oversizing on Postwelding Distortions of the Fillet Welded Joint

Pubblicato online: 30 dic 2015

Pagine: 59 - 63

DOI: https://doi.org/10.1515/pomr-2015-0072

Parole chiave
welding distortion, shipbuilding welding, welding angular distortion

© 2016

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

The Influence of Manufacturing Oversizing on Postwelding Distortions of the Fillet Welded Joint

Pubblicato online: 30 dic 2015

Pagine: 59 - 63

DOI: https://doi.org/10.1515/pomr-2015-0072

Parole chiavewelding distortion, shipbuilding welding, welding angular distortion

© 2016

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

Parole chiave
welding distortion, shipbuilding welding, welding angular distortion