<abstract xmlns="http://www.w3.org/1999/xhtml">

In the scope of the green energy and climatic changes waste poses as a great resource as an alternative fuel or source for their production. This helps to decrease the need for fossil resources, as well as diversify energy production. This kind of waste utilization and mitigation therefore directly fits into latest legislation and green initiatives. This paper focuses on the influence of five synthesis gases with relatively high heating values on the internal parameters of the internal combustion engine intended for cogeneration. Measurements show that proportion of the hydrogen in the mixture has indirect influence on the combustion duration and also maximal pressure rise rate. Interestingly hydrogen proportion in fuel showed no direct influence on the maximal in-cylinder pressure. Higher CO to CH4 ratio reduced burn time and increased maximal combustion pressure with slightly decreased performance. Concentration of CH4 directly influenced volumetric <italic>LHV</italic> value of the mixture with subsequent influence on the <italic>IMEP</italic> and engine effective torque. Generally, operation of the engine at full load at 1500 min−1 on chosen mixtures compared to the runs on methane showed decrease of engine torque output of up to 13.4% and increase of the hourly fuel consumption from 1.56 for pure methane to maximally 3.87 kg.h−1 for measured gases. Lastly, for one of the fuels erratic engine operation was observed.
</abstract>

In the scope of the green energy and climatic changes waste poses as a great resource as an alternative fuel or source for their production. This helps to decrease the need for fossil resources, as well as diversify energy production. This kind of waste utilization and mitigation therefore directly fits into latest legislation and green initiatives. This paper focuses on the influence of five synthesis gases with relatively high heating values on the internal parameters of the internal combustion engine intended for cogeneration. Measurements show that proportion of the hydrogen in the mixture has indirect influence on the combustion duration and also maximal pressure rise rate. Interestingly hydrogen proportion in fuel showed no direct influence on the maximal in-cylinder pressure. Higher CO to CH4 ratio reduced burn time and increased maximal combustion pressure with slightly decreased performance. Concentration of CH4 directly influenced volumetric LHV value of the mixture with subsequent influence on the IMEP and engine effective torque. Generally, operation of the engine at full load at 1500 min−1 on chosen mixtures compared to the runs on methane showed decrease of engine torque output of up to 13.4% and increase of the hourly fuel consumption from 1.56 for pure methane to maximally 3.87 kg.h−1 for measured gases. Lastly, for one of the fuels erratic engine operation was observed.

Combustion of Synthesis Gas with the Constant Amount of Inert Gases in the Microcogeneration Unit Engine

Slovak University of Technology in Bratislava, Faculty of Mechanical Engineering

Strojnícky časopis - Journal of Mechanical Engineering

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

In the scope of the green energy and climatic changes waste poses as a great resource as an alternative fuel or source for their production. This helps to...

Combustion of Synthesis Gas with the Constant Amount of Inert Gases in the Microcogeneration Unit Engine

Publié en ligne: 01 juin 2024

Pages: 25 - 34

DOI: https://doi.org/10.2478/scjme-2024-0003

Mots clés
Synthesis gas, Combustion engine, Alternative fuel, Municipal waste, Waste to fuel

© 2024 Andrej Chríbik et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Combustion of Synthesis Gas with the Constant Amount of Inert Gases in the Microcogeneration Unit Engine

Publié en ligne: 01 juin 2024

Pages: 25 - 34

DOI: https://doi.org/10.2478/scjme-2024-0003

Mots clésSynthesis gas, Combustion engine, Alternative fuel, Municipal waste, Waste to fuel

© 2024 Andrej Chríbik et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Mots clés
Synthesis gas, Combustion engine, Alternative fuel, Municipal waste, Waste to fuel