<abstract xmlns="http://www.w3.org/1999/xhtml"><p>In practice, pipe products are often produced. The surfaces of these components are often turned. The three-jaw chuck is often used to clamp the components for turning. It is a universal clamping fixture. The main advantage of three-jaw chuck is its high flexibility. However, its disadvantage is the inappropriate influence of the clamping forces on the geometrical accuracy of the produced components. This article deals with research of the influence of clamping forces on the roundness of turned pipes. A universal three-jaw chuck was used. The chuck was tightened using a torque wrench. The applied tighten torques were determined by monitoring the commonly used torques for a manually tightened chuck. The article presents the results of experimental research.</p></abstract>

In practice, pipe products are often produced. The surfaces of these components are often turned. The three-jaw chuck is often used to clamp the components for turning. It is a universal clamping fixture. The main advantage of three-jaw chuck is its high flexibility. However, its disadvantage is the inappropriate influence of the clamping forces on the geometrical accuracy of the produced components. This article deals with research of the influence of clamping forces on the roundness of turned pipes. A universal three-jaw chuck was used. The chuck was tightened using a torque wrench. The applied tighten torques were determined by monitoring the commonly used torques for a manually tightened chuck. The article presents the results of experimental research.

Research of the Influence of Clamping Forces on the Roundness Deviations of the Pipes Turned Surface

Slovak University of Technology in Bratislava

Faculty of Materials Science and Technology in Trnava, Institute of Production Technologies

Research Papers Faculty of Materials Science and Technology Slovak University of Technology

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

In practice, pipe products are often produced. The surfaces of these components are often turned. The three-jaw chuck is often used to clamp the components for...

Research of the Influence of Clamping Forces on the Roundness Deviations of the Pipes Turned Surface

Publié en ligne: 04 oct. 2018

Pages: 47 - 54

Reçu: 24 mai 2018

Accepté: 19 juin 2018

DOI: https://doi.org/10.2478/rput-2018-0005

Mots clés
Pipe, three-jaw chuck, clamping forces, tightening torques, roundness

© 2018 Augustín Görög et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Research of the Influence of Clamping Forces on the Roundness Deviations of the Pipes Turned Surface

Publié en ligne: 04 oct. 2018

Pages: 47 - 54

Reçu: 24 mai 2018

Accepté: 19 juin 2018

DOI: https://doi.org/10.2478/rput-2018-0005

Mots clésPipe, three-jaw chuck, clamping forces, tightening torques, roundness

© 2018 Augustín Görög et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Mots clés
Pipe, three-jaw chuck, clamping forces, tightening torques, roundness