<abstract xmlns="http://www.w3.org/1999/xhtml">Production of refuse derived fuel from municipal solid waste in future shall play a strategic role in an integrated waste management system. The amount of landfilled biodegradable materials thus will be diminished according to provisions of the 1999 Waste Landfill Directive. The aim of this article is to evaluate cost effectiveness based on cost evaluation of the different complication of the waste pre-treatment equipment complectation and based on regenerable waste quantities in Latvia. The comparison of cost estimates is done in 3 scenarios considering potential waste quantities in Latvia: Scenario I - planned annual waste quantity is 20 kT; Scenario II - 40 kT and Scenario III - 160 kT. An increase in amount of waste and processing capacity means the decrease in costs of mechanical pre-treatment of 1 ton of waste. Thus, costs of mechanical sorting line under different scenarios with capacities of 10 t h-1, 20 t h-1 and 80 t h-1 are EUR 32 per t, EUR 24 per t and EUR 15 per t, respectively. Most feasible cost for a set of mechanical pre-treatment equipment for the capacity of 10 t h-1 is EUR 32 per t by using rotating drum screener with the following manual sorting. Mechanical pre-treatment equipment of unsorted municipal waste is economically nonbeneficial, when the use of fine (biologically degradable) fraction is not possible. As the sorting of biodegradable kitchen waste is not developed under the current waste management system in Latvia, the lines for mechanical pre-treatment of household waste would be better to install in landfills.</abstract>

Production of refuse derived fuel from municipal solid waste in future shall play a strategic role in an integrated waste management system. The amount of landfilled biodegradable materials thus will be diminished according to provisions of the 1999 Waste Landfill Directive. The aim of this article is to evaluate cost effectiveness based on cost evaluation of the different complication of the waste pre-treatment equipment complectation and based on regenerable waste quantities in Latvia. The comparison of cost estimates is done in 3 scenarios considering potential waste quantities in Latvia: Scenario I - planned annual waste quantity is 20 kT; Scenario II - 40 kT and Scenario III - 160 kT. An increase in amount of waste and processing capacity means the decrease in costs of mechanical pre-treatment of 1 ton of waste. Thus, costs of mechanical sorting line under different scenarios with capacities of 10 t h-1, 20 t h-1 and 80 t h-1 are EUR 32 per t, EUR 24 per t and EUR 15 per t, respectively. Most feasible cost for a set of mechanical pre-treatment equipment for the capacity of 10 t h-1 is EUR 32 per t by using rotating drum screener with the following manual sorting. Mechanical pre-treatment equipment of unsorted municipal waste is economically nonbeneficial, when the use of fine (biologically degradable) fraction is not possible. As the sorting of biodegradable kitchen waste is not developed under the current waste management system in Latvia, the lines for mechanical pre-treatment of household waste would be better to install in landfills.

The Cost-estimation of Mechanical Pre-treatment Lines of Municipal Solid Waste in Latvia

Department of Environment and Water Management, LLU, Akademijas iela 19, Jelgava, LV-3001, Latvia

Institute of Energy Systems and Environment, RTU, Kalku iela 1, Riga, LV-1658, Latvia

Department of Environmental Science, LU, Raina bulv.19, Riga, LV-1586, Latvia

Rural Sustainability Research

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Production of refuse derived fuel from municipal solid waste in future shall play a strategic role in an integrated waste management system. The amount of...

The Cost-estimation of Mechanical Pre-treatment Lines of Municipal Solid Waste in Latvia

Publié en ligne: 30 déc. 2014

Pages: 17 - 28

DOI: https://doi.org/10.2478/plua-2014-0009

Mots clés
mechanical pre-treatment, municipal solid waste, capital costs, operation costs

© by Dace Āriņa

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

The Cost-estimation of Mechanical Pre-treatment Lines of Municipal Solid Waste in Latvia

Publié en ligne: 30 déc. 2014

Pages: 17 - 28

DOI: https://doi.org/10.2478/plua-2014-0009

Mots clésmechanical pre-treatment, municipal solid waste, capital costs, operation costs

© by Dace Āriņa

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Mots clés
mechanical pre-treatment, municipal solid waste, capital costs, operation costs