<abstract xmlns="http://www.w3.org/1999/xhtml">

<p>The paper presents an approach to the modelling of a cyclic battery tester and contains observations about lithium-ion (Li-ion) batteries, charging/discharging procedures, conditions and protections which must be observed during the testing process. The main goal was to create and simulate a schematic which will be capable of cyclically testing Li-ion battery cells. Regulation of the final schematic is based on cascade connections of operation amplifiers, which work as a voltage source with current-limiting functions. The power part is created by two MOSFETs connected as a half-bridge. This topology allows current to flow in both directions (from and to the battery). Final simulation is supplemented by protections such as reverse polarity protection, short circuit protection and overvoltage protection during charging. Proper operation of the whole connection is demonstrated by the simulation outputs in the final section.</p>
</abstract>

The paper presents an approach to the modelling of a cyclic battery tester and contains observations about lithium-ion (Li-ion) batteries, charging/discharging procedures, conditions and protections which must be observed during the testing process. The main goal was to create and simulate a schematic which will be capable of cyclically testing Li-ion battery cells. Regulation of the final schematic is based on cascade connections of operation amplifiers, which work as a voltage source with current-limiting functions. The power part is created by two MOSFETs connected as a half-bridge. This topology allows current to flow in both directions (from and to the battery). Final simulation is supplemented by protections such as reverse polarity protection, short circuit protection and overvoltage protection during charging. Proper operation of the whole connection is demonstrated by the simulation outputs in the final section.

Design and Simulation of Cyclic Battery Tester

Department of Electrical Engineering and Mechatronics, Faculty of Electrical Engineering and Informatics

Power Electronics and Drives

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

{"article-title":"Design and Simulation of Cyclic Battery Tester"}

The paper presents an approach to the modelling of a cyclic battery tester and contains observations about lithium-ion (Li-ion) batteries, charging/discharging...

Design and Simulation of Cyclic Battery Tester

Publié en ligne: 28 déc. 2020

Pages: 229 - 241

Reçu: 22 nov. 2020

Accepté: 07 déc. 2020

DOI: https://doi.org/10.2478/pead-2020-0017

Mots clés
battery, cell, charging, discharging, Simscape

© 2020 Juraj Bilansky et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Design and Simulation of Cyclic Battery Tester

Publié en ligne: 28 déc. 2020

Pages: 229 - 241

Reçu: 22 nov. 2020

Accepté: 07 déc. 2020

DOI: https://doi.org/10.2478/pead-2020-0017

Mots clésbattery, cell, charging, discharging, Simscape

© 2020 Juraj Bilansky et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Mots clés
battery, cell, charging, discharging, Simscape