Verification of Coordinate Measuring Machine Using a Gauge Block

Institute of Special Engineering Processes, Department of Biomedical Engineering and Measurement, Faculty of Mechanical Engineering, Technical University in KošiceKošice, Slovakia

Dovica, Miroslav

Institute of Special Engineering Processes, Department of Biomedical Engineering and Measurement, Faculty of Mechanical Engineering, Technical University in KošiceKošice, Slovakia

Buša, Ján

Laboratory of Information Technologies, Joint Institute for Nuclear ResearchDubna, Russia

Buša, Ján

Laboratory of Information Technologies, Joint Institute for Nuclear ResearchDubna, Russia

Langue:: Anglais

Périodicité:: 6 fois par an
Sujets de la revue:: Ingénierie, Ingénierie électrique, Ingénierie de contrôle, métrologie et essais

RSS Feed de la revue

Verification of Coordinate Measuring Machine Using a Gauge Block

Teodor Tóth

Miroslav Dovica

Ján Buša

Ján Buša

Publié en ligne: 24 déc. 2024

Pages: 226 - 233

Reçu: 31 mai 2024

Accepté: 20 nov. 2024

DOI: https://doi.org/10.2478/msr-2024-0030

Mots clésMetrology, 3D contact / touch measuring device, gauge block, minimization, Newton method, singular value decomposition

© 2024 Teodor Tóth et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Mots clés
Metrology, 3D contact / touch measuring device, gauge block, minimization, Newton method, singular value decomposition