<abstract xmlns="http://www.w3.org/1999/xhtml">This work is focused on determining the capability of production equipment in Volkswagen Slovakia, a.s. during the moulding of a car door. There were taken 150 samples from the moulding process that followed each other. Values were recorded on a Wenzel RAplus 1625 measuring machine. Subsequently, process stability was verified. It showed that measured values had a stable average value, and the process did not show irregularities in the diagrams of the <italic>X</italic> card and s card. After verification of stability, the values of <italic>Cm</italic> and <italic>Cmk</italic> were calculated, which exceeded the minimum requirement of 1.66 and 1.67, and the requirements for the capability of production equipment have thereby been met.</abstract>

This work is focused on determining the capability of production equipment in Volkswagen Slovakia, a.s. during the moulding of a car door. There were taken 150 samples from the moulding process that followed each other. Values were recorded on a Wenzel RAplus 1625 measuring machine. Subsequently, process stability was verified. It showed that measured values had a stable average value, and the process did not show irregularities in the diagrams of the X card and s card. After verification of stability, the values of Cm and Cmk were calculated, which exceeded the minimum requirement of 1.66 and 1.67, and the requirements for the capability of production equipment have thereby been met.

Monitoring the Capability of Production Equipment in Organization

Slovak University of Agriculture in Nitra, Slovak Republic

Acta Technologica Agriculturae

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

{"article-title":"Monitoring the Capability of Production Equipment in Organization"}

This work is focused on determining the capability of production equipment in Volkswagen Slovakia, a.s. during the moulding of a car door. There were taken 150...

Monitoring the Capability of Production Equipment in Organization

Publié en ligne: 15 août 2014

Pages: 39 - 43

DOI: https://doi.org/10.2478/ata-2014-0009

© 2014 Slovak University of Agriculture in Nitra

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.