Results of Simulation and Physical Modeling of the Computerized Monitoring and Control System for Greenhouse Microclimate Parameters
, , et
07 févr. 2019
À propos de cet article
Catégorie d'article: Research-Article
Publié en ligne: 07 févr. 2019
Pages: 1 - 15
Reçu: 15 janv. 2018
Accepté: 19 sept. 2018
DOI: https://doi.org/10.21307/ijssis-2018-017
Mots clés
© 2018 I.S. Laktionov et al., published by Sciendo
This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13
Proposed methods for disadvantages eliminating_
| Research phase | Used approaches and their characteristics |
|---|---|
| Regression analysis of the sensor conversion characteristics | Based on MS Excel and Mathcad. It allowed to obtain analytical dependencies of the measured parameters, which are the basis for program code |
| Prototyping of the system | Based on the Fritzing software product. It allowed to increase ergonomic indicators of research results |
| Simulation modeling of the microprocessor system | Based on Proteus 8.0 (hardware component) and Arduino IDE (software component). It allowed to test the developed structural and algorithmic organization of the system |
| Analysis of research results | This stage was carried out by comparing of the simulation results and laboratory tests |