<abstract xmlns="http://www.w3.org/1999/xhtml">Nano porous sol gel thin film humidity sensor was studied using commercially available reference humidity sensor from Honeywell Corporation. The main advantages of our developed set up for humidity measurements is low cost and high resolution yielding a full set of information on the variation of humidity at 250°C. Humidity is considered to be one of the most effective indicators of the leakage. On this ground we developed nano porous sensor which can be used for LBB (Leak before break) application. The ceramic sensors, based on sol gel thin film are shown to increase its capacitance upon water adsorption over the temperature range upto 250°C. The variation of capacity to voltage is shown to provide useful information on both break rate and location. The sensor installation spacing on the outer surface of the piping is determined as a function of the detection sensitivity. In this paper we have summarize the results of the development and characterization of ceramic humidity sensor for leak rate and location analysis by a microcontroller device</abstract>

Nano porous sol gel thin film humidity sensor was studied using commercially available reference humidity sensor from Honeywell Corporation. The main advantages of our developed set up for humidity measurements is low cost and high resolution yielding a full set of information on the variation of humidity at 250°C. Humidity is considered to be one of the most effective indicators of the leakage. On this ground we developed nano porous sensor which can be used for LBB (Leak before break) application. The ceramic sensors, based on sol gel thin film are shown to increase its capacitance upon water adsorption over the temperature range upto 250°C. The variation of capacity to voltage is shown to provide useful information on both break rate and location. The sensor installation spacing on the outer surface of the piping is determined as a function of the detection sensitivity. In this paper we have summarize the results of the development and characterization of ceramic humidity sensor for leak rate and location analysis by a microcontroller device

Leak Rate And Location Analysis Through Slits And Cracks In Pipes By Nano Porous CeramiC Humidity Sensors

International Journal on Smart Sensing and Intelligent Systems

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Nano porous sol gel thin film humidity sensor was studied using commercially available reference humidity sensor from Honeywell Corporation. The main...

Leak Rate And Location Analysis Through Slits And Cracks In Pipes By Nano Porous CeramiC Humidity Sensors

Publié en ligne: 13 déc. 2017

Pages: 784 - 798

DOI: https://doi.org/10.21307/ijssis-2017-320

Mots clés
Nano porous H. sensor, Linearization, Microcontroller circuit, Leak location

© 2008 Dilip Kumar Ghara et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Leak Rate And Location Analysis Through Slits And Cracks In Pipes By Nano Porous CeramiC Humidity Sensors

Publié en ligne: 13 déc. 2017

Pages: 784 - 798

DOI: https://doi.org/10.21307/ijssis-2017-320

Mots clésNano porous H. sensor, Linearization, Microcontroller circuit, Leak location

© 2008 Dilip Kumar Ghara et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Mots clés
Nano porous H. sensor, Linearization, Microcontroller circuit, Leak location