<abstract xmlns="http://www.w3.org/1999/xhtml"><p>Cu–Sn–Fe alloys with different compositions were developed by casting, normalizing treatment, cold roll and subsequent annealing treatment. The results showed that the tensile strength and resistivity of the Cu–xSn–xFe alloys (where x represents wt.%) improved with increasing the content of Sn and Fe. Compared with the as-cast alloys, the resistivity and tensile strength of the Cu–xSn–xFe alloys after normalizing and cold rolling treatment increased. In addition, the resistivity and mechanical properties of the alloys after the annealing treatment were improved significantly. Finally, a conclusion could be drawn that the annealed Cu–2Sn–5Fe alloy had good mechanical properties and resistivity, and the values of the tensile strength, mechanical elongation and resistivity reached 552 MPa, 32 % and 1.92 μΩ cm, respectively.</p></abstract>

Cu–Sn–Fe alloys with different compositions were developed by casting, normalizing treatment, cold roll and subsequent annealing treatment. The results showed that the tensile strength and resistivity of the Cu–xSn–xFe alloys (where x represents wt.%) improved with increasing the content of Sn and Fe. Compared with the as-cast alloys, the resistivity and tensile strength of the Cu–xSn–xFe alloys after normalizing and cold rolling treatment increased. In addition, the resistivity and mechanical properties of the alloys after the annealing treatment were improved significantly. Finally, a conclusion could be drawn that the annealed Cu–2Sn–5Fe alloy had good mechanical properties and resistivity, and the values of the tensile strength, mechanical elongation and resistivity reached 552 MPa, 32 % and 1.92 μΩ cm, respectively.

Study of high-strength and high-conductivity Cu–Sn–Fe alloys

School of Applied Science, Taiyuan University of Science and Technology, Taiyuan 030024,

Institute of Materials Science and Technology, Taiyuan University of Science and Technology, Taiyuan 030024,

Materials Science-Poland

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

{"article-title":"Study of high-strength and high-conductivity Cu\u2013Sn\u2013Fe alloys"}

Cu–Sn–Fe alloys with different compositions were developed by casting, normalizing treatment, cold roll and subsequent annealing treatment. The results showed...

Study of high-strength and high-conductivity Cu–Sn–Fe alloys

Article Category: Research Article

Publié en ligne: 27 avr. 2016

Pages: 142 - 147

Reçu: 31 juil. 2015

Accepté: 24 nov. 2015

DOI: https://doi.org/10.1515/msp-2016-0015

Mots clés
Cu–Sn–Fe alloy, conductive material, tensile strength, resistivity

© 2016 Wroclaw University of Technology

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Study of high-strength and high-conductivity Cu–Sn–Fe alloys

Article Category: Research Article

Publié en ligne: 27 avr. 2016

Pages: 142 - 147

Reçu: 31 juil. 2015

Accepté: 24 nov. 2015

DOI: https://doi.org/10.1515/msp-2016-0015

Mots clésCu–Sn–Fe alloy, conductive material, tensile strength, resistivity

© 2016 Wroclaw University of Technology

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Mots clés
Cu–Sn–Fe alloy, conductive material, tensile strength, resistivity