<abstract xmlns="http://www.w3.org/1999/xhtml"><p>This article is focused on the stress analyses of the welded structure of the device designed to the scales calibrating with maximum loading capacity up to ten tons. The article includes basic knowledges of the theory of elasticity and stress analysis and numerical method called Finite Element Method that were used for the task solution. Cores of the work were stress analyses of selected parts of the designed structure of the device. For stress analyses the ADINA numerical software was used. Results of analyses of the primary design device showed that strength in same locations did not respond to the required maximal load. The structure in critical locations was modified and subsequently reanalyses confirmed the sufficient strength with prescribed safety factor.</p></abstract>

This article is focused on the stress analyses of the welded structure of the device designed to the scales calibrating with maximum loading capacity up to ten tons. The article includes basic knowledges of the theory of elasticity and stress analysis and numerical method called Finite Element Method that were used for the task solution. Cores of the work were stress analyses of selected parts of the designed structure of the device. For stress analyses the ADINA numerical software was used. Results of analyses of the primary design device showed that strength in same locations did not respond to the required maximal load. The structure in critical locations was modified and subsequently reanalyses confirmed the sufficient strength with prescribed safety factor.

Stress Analysis of the Framework of a Device Designed for Scales Calibrating

Department of Transport and Handling Machines

Volodymyr Dahl East Ukrainian National University

LOGI – Scientific Journal on Transport and Logistics

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

{"article-title":"Stress Analysis of the Framework of a Device Designed for Scales Calibrating"}

This article is focused on the stress analyses of the welded structure of the device designed to the scales calibrating with maximum loading capacity up to ten...

Stress Analysis of the Framework of a Device Designed for Scales Calibrating

Publié en ligne: 12 juin 2017

Pages: 20 - 27

DOI: https://doi.org/10.1515/logi-2017-0003

Mots clés
Stress analysis, Finite element method, test device, vehicle axle scales

© 2017 Miroslav Blatnický et al., published by De Gruyter Open

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Stress Analysis of the Framework of a Device Designed for Scales Calibrating

Publié en ligne: 12 juin 2017

Pages: 20 - 27

DOI: https://doi.org/10.1515/logi-2017-0003

Mots clésStress analysis, Finite element method, test device, vehicle axle scales

© 2017 Miroslav Blatnický et al., published by De Gruyter Open

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Mots clés
Stress analysis, Finite element method, test device, vehicle axle scales