<abstract xml:lang="en" xmlns="http://www.w3.org/1999/xhtml"><p> Nowadays, number of customer and environmental requirements are laid to the automotive industry. These are related to safety increase, the weight and emission reduction as well as the life-time improvement. The article presents the way to improve the corrosion resistance of the car-body components when coated steel sheets are used based on Zn-Al-Mg coatings. Thus, the life-time of the car-body is improved. Samples with conventional Zn coating and samples with advanced Zn-Al-Mg coatings were deformed by stretching and 3-point bending to 90° and 180° tests. Consequently, the samples were exposed to salt spray in the corrosion chamber. Time to red corrosion appearance and adequate percentage of corroded surface was evaluated. The results showed the better corrosion protection of Zn-Al-Mg coatings when compared to the conventional Zn coating.</p></abstract>

Nowadays, number of customer and environmental requirements are laid to the automotive industry. These are related to safety increase, the weight and emission reduction as well as the life-time improvement. The article presents the way to improve the corrosion resistance of the car-body components when coated steel sheets are used based on Zn-Al-Mg coatings. Thus, the life-time of the car-body is improved. Samples with conventional Zn coating and samples with advanced Zn-Al-Mg coatings were deformed by stretching and 3-point bending to 90° and 180° tests. Consequently, the samples were exposed to salt spray in the corrosion chamber. Time to red corrosion appearance and adequate percentage of corroded surface was evaluated. The results showed the better corrosion protection of Zn-Al-Mg coatings when compared to the conventional Zn coating.

Analysis of the galvanised steel sheets resistance to corrosion after plastic deformation

Technická univerzita v Košiciach, Strojnícka fakulta, Katedra automobilovej výroby,

Technická univerzita v Košiciach, Strojnícka fakulta, Katedra počítačovej podpory technológií,

U.S.Steel Košice, s.r.o., Výskumný a skúšobný ústav,

Koroze a ochrana materiálu

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

Nowadays, number of customer and environmental requirements are laid to the automotive industry. These are related to safety increase, the weight and emission...

Analysis of the galvanised steel sheets resistance to corrosion after plastic deformation

Publié en ligne: 08 déc. 2016

Pages: 114 - 121

DOI: https://doi.org/10.1515/kom-2016-0018

© by E. Evin

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.