<abstract xmlns="http://www.w3.org/1999/xhtml"><p> In this paper it is analyzed the welded T-joint exposed to the axial tensile force and the bending moment, for determining the impact of the weld geometry on the fracture mechanics parameters. The stress intensity factor was calculated analytically, based on the concept of the linear elastic fracture mechanics (LEFM), by application of the Mathematica<sup>®</sup> programming routine. The presence of the weld was taken into account through the corresponding correction factors. The results show that increase of the size of the triangular welds leads to decrease of the stress intensity factor, while the SIF increases with increase of the welds’ width. The ratio of the two welded plates’ thicknesses shows that plate thicknesses do not exhibit significant influence on the stress intensity factor behavior.</p></abstract>

In this paper it is analyzed the welded T-joint exposed to the axial tensile force and the bending moment, for determining the impact of the weld geometry on the fracture mechanics parameters. The stress intensity factor was calculated analytically, based on the concept of the linear elastic fracture mechanics (LEFM), by application of the Mathematica® programming routine. The presence of the weld was taken into account through the corresponding correction factors. The results show that increase of the size of the triangular welds leads to decrease of the stress intensity factor, while the SIF increases with increase of the welds’ width. The ratio of the two welded plates’ thicknesses shows that plate thicknesses do not exhibit significant influence on the stress intensity factor behavior.

Impact of the Weld Geometry on the Stress Intensity Factor of the Welded T-Joint Exposed to the Tensile Force and the Bending Moment

Technical Faculty of Bor, Vojske Jugoslavije 12, 19210 Bor, Serbia

Faculty of Engineering, University of Kragujevac, Sestre Janjić 6, 34000 Kragujevac, Serbia. Research Center, University of Žilina, Univerzitná 1, 01026 Žilina, Slovakia

Faculty of Civil Engineering, University of Žilina, Univerzitná 1, 01026 Žilina, Slovakia

Civil and Environmental Engineering

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

In this paper it is analyzed the welded T-joint exposed to the axial tensile force and the bending moment, for determining the impact of the weld geometry on...

Impact of the Weld Geometry on the Stress Intensity Factor of the Welded T-Joint Exposed to the Tensile Force and the Bending Moment

Publié en ligne: 12 déc. 2015

Pages: 103 - 109

DOI: https://doi.org/10.1515/cee-2015-0013

Mots clés
Welding, T-joint, Filled weld, Stress Intensity Factor (SIF), LEFM concept

© 2015

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

Impact of the Weld Geometry on the Stress Intensity Factor of the Welded T-Joint Exposed to the Tensile Force and the Bending Moment

Publié en ligne: 12 déc. 2015

Pages: 103 - 109

DOI: https://doi.org/10.1515/cee-2015-0013

Mots clésWelding, T-joint, Filled weld, Stress Intensity Factor (SIF), LEFM concept

© 2015

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

Mots clés
Welding, T-joint, Filled weld, Stress Intensity Factor (SIF), LEFM concept