<abstract xmlns="http://www.w3.org/1999/xhtml"><p>The article presents the results of tensile strength tests taking into account the influence of the printing nozzle diameter. The 3D printing method in FDM technology is described. The aim of the research was to investigate the effect of the printing nozzle diameter installed in the head. Samples printed with two types of filling were tested. The obtained results were summarized and compared. The printing time of the samples was compared with a diameter of each nozzle. Based on the strength tests, it can be concluded that the tensile strength of the samples made with the FDM printing technology is proportional to the used printing nozzle diameter.</p></abstract>

The article presents the results of tensile strength tests taking into account the influence of the printing nozzle diameter. The 3D printing method in FDM technology is described. The aim of the research was to investigate the effect of the printing nozzle diameter installed in the head. Samples printed with two types of filling were tested. The obtained results were summarized and compared. The printing time of the samples was compared with a diameter of each nozzle. Based on the strength tests, it can be concluded that the tensile strength of the samples made with the FDM printing technology is proportional to the used printing nozzle diameter.

Influence of the Printing Nozzle Diameter on Tensile Strength of Produced 3D Models in FDM Technology

University of Warmia and Mazury in Olsztyn

Agricultural Engineering

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

The article presents the results of tensile strength tests taking into account the influence of the printing nozzle diameter. The 3D printing method in FDM...

Influence of the Printing Nozzle Diameter on Tensile Strength of Produced 3D Models in FDM Technology

Publié en ligne: 30 sept. 2020

Pages: 31 - 38

Reçu: 01 août 2020

Accepté: 01 sept. 2020

DOI: https://doi.org/10.1515/agriceng-2020-0024

Mots clés
3D printing, FDM, 3D printing analysis, strength tests

© 2020 Wojciech Kiński et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Influence of the Printing Nozzle Diameter on Tensile Strength of Produced 3D Models in FDM Technology

Publié en ligne: 30 sept. 2020

Pages: 31 - 38

Reçu: 01 août 2020

Accepté: 01 sept. 2020

DOI: https://doi.org/10.1515/agriceng-2020-0024

Mots clés3D printing, FDM, 3D printing analysis, strength tests

© 2020 Wojciech Kiński et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Mots clés
3D printing, FDM, 3D printing analysis, strength tests