New possibilities for in situ CT analysis of additive manufactured samples
Grzegorz Ziółkowski
Faculty of Mechanical Engineering, Centre for Advanced Manufacturing Technologies (CAMT/FPC), Wroclaw University of Science and Technology
Perfil de OrcidBuscar este autor en
, Grzegorz Treter
Faculty of Mechanical Engineering, Centre for Advanced Manufacturing Technologies (CAMT/FPC), Wroclaw University of Science and Technology
Perfil de OrcidBuscar este autor en
, Emilia Tokarczyk
Faculty of Mechanical Engineering, Centre for Advanced Manufacturing Technologies (CAMT/FPC), Wroclaw University of Science and Technology
Perfil de OrcidBuscar este autor en
y Patrycja Szymczyk-Ziółkowska
Faculty of Mechanical Engineering, Centre for Advanced Manufacturing Technologies (CAMT/FPC), Wroclaw University of Science and Technology
Perfil de OrcidBuscar este autor en
19 sept 2020
Acerca de este artículo
Publicado en línea: 19 sept 2020
Recibido: 16 oct 2019
Aceptado: 09 sept 2020
DOI: https://doi.org/10.37705/TechTrans/e2020028
Palabras clave
© 2020 Grzegorz Ziółkowski et al., published by Sciendo
This work is licensed under the Creative Commons Attribution-ShareAlike 4.0 International License.
Industrial Computed Tomography (CT) is a broadly used measurement method allowing for quality control of objects produced using additive manufacturing methods. The combination of tensile tests and simultaneous 3D imaging of the behavior of an object under a particular force (i.e. in situ examination – during the process) significantly broadens the possibilities of analyzing objects with a complex internal geometry. The purpose of this paper is to present the author’s project of a mini testing machine, to verify its functioning with regards to a static testing machine, and to present the initial in situ examination results for polymer samples.