<abstract xmlns="http://www.w3.org/1999/xhtml"><p>Research in 60s and 70s started to deal with the shape of the chip characterization. It was possible then to do a limited study by means of measuring tool park. During such a study, different models for chip formation became familiar, such as the Time or Merchant model. The aim of article is to gain insight into some accompanying phenomena, occurring while cutting of different materials and with various tools. During an experimental design, the possible effects of different variables on each other and individually were considered. Two work-pieces (C45, POM) with two inserts (with two different edge design) were tested while changing of cutting speed and feed. During measurements cutting forces at 5000 Hz signal reception were tested or the evolution of cutting temperature at different experimental settings was evaluated. The chip characteristics are measured by a high speed camera. The camera is connected with PC for recording and controlling the experimental procedure in real-time. The frequency of High Speed Camera was similar than the frequency of the cutting force measuring system. This similarity is provided with the system set-up synchronization.</p></abstract>

Research in 60s and 70s started to deal with the shape of the chip characterization. It was possible then to do a limited study by means of measuring tool park. During such a study, different models for chip formation became familiar, such as the Time or Merchant model. The aim of article is to gain insight into some accompanying phenomena, occurring while cutting of different materials and with various tools. During an experimental design, the possible effects of different variables on each other and individually were considered. Two work-pieces (C45, POM) with two inserts (with two different edge design) were tested while changing of cutting speed and feed. During measurements cutting forces at 5000 Hz signal reception were tested or the evolution of cutting temperature at different experimental settings was evaluated. The chip characteristics are measured by a high speed camera. The camera is connected with PC for recording and controlling the experimental procedure in real-time. The frequency of High Speed Camera was similar than the frequency of the cutting force measuring system. This similarity is provided with the system set-up synchronization.

Chip breaking phenomenon during cutting steel and polymer materials

GAMF Faculty of Engineering and Computer Science

Production Engineering Archives

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

{"article-title":"Chip breaking phenomenon during cutting steel and polymer materials"}

Research in 60s and 70s started to deal with the shape of the chip characterization. It was possible then to do a limited study by means of measuring tool...

Chip breaking phenomenon during cutting steel and polymer materials

Publicado en línea: 28 ene 2020

Páginas: 37 - 42

Recibido: 30 jun 2017

Aceptado: 15 sept 2017

DOI: https://doi.org/10.30657/pea.2017.16.08

Palabras clave
Cutting forces, Cutting temperature, High Speed Camera, Polymer, Turning

© 2017 János Líska, published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Chip breaking phenomenon during cutting steel and polymer materials

Publicado en línea: 28 ene 2020

Páginas: 37 - 42

Recibido: 30 jun 2017

Aceptado: 15 sept 2017

DOI: https://doi.org/10.30657/pea.2017.16.08

Palabras claveCutting forces, Cutting temperature, High Speed Camera, Polymer, Turning

© 2017 János Líska, published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Palabras clave
Cutting forces, Cutting temperature, High Speed Camera, Polymer, Turning