<abstract xmlns="http://www.w3.org/1999/xhtml"><p>In the paper I investigated the effect of the GLONASS-specific receiver antenna phase center corrections on the results of a regional permanent GNSS network. I made analysis, using Bernese GPS Software 5.0, of GPS-only and GPS-GLONASS (GNSS) observations collected at permanent sites in Europe. Two types of GNSS solutions were computed: with GPS phase center corrections used for observations of both systems, and with the system specific corrections for observations of the respective system. The Bernese software was modified accordingly to use GLONASS specific corrections for GLONASS measurements. The results, i.e., coordinates and tropospheric zenith delays were analyzed and compared between computed solutions. Introducing GLONASS-specific receiver antenna phase center corrections did not improve the repeatability of the GNSS coordinate time series. Differences of coordinates between the two GNSS solutions were highly repeatable but offsets (biases) were observed; maximum bias for horizontal component was 1 mm and 4 mm for up component. Similar biases were observed for stations with the same antenna models. Periodic signal with a period of 1/3-year was found in difference time series between GPS and GNSS solutions for north component with a maximum peak-to-peak amplitude 2.8 mm. The periodic signal was attributed to GLONASS.</p></abstract>

In the paper I investigated the effect of the GLONASS-specific receiver antenna phase center corrections on the results of a regional permanent GNSS network. I made analysis, using Bernese GPS Software 5.0, of GPS-only and GPS-GLONASS (GNSS) observations collected at permanent sites in Europe. Two types of GNSS solutions were computed: with GPS phase center corrections used for observations of both systems, and with the system specific corrections for observations of the respective system. The Bernese software was modified accordingly to use GLONASS specific corrections for GLONASS measurements. The results, i.e., coordinates and tropospheric zenith delays were analyzed and compared between computed solutions. Introducing GLONASS-specific receiver antenna phase center corrections did not improve the repeatability of the GNSS coordinate time series. Differences of coordinates between the two GNSS solutions were highly repeatable but offsets (biases) were observed; maximum bias for horizontal component was 1 mm and 4 mm for up component. Similar biases were observed for stations with the same antenna models. Periodic signal with a period of 1/3-year was found in difference time series between GPS and GNSS solutions for north component with a maximum peak-to-peak amplitude 2.8 mm. The periodic signal was attributed to GLONASS.

Effect of the Glonass-Specific Receiver Antenna Phase Center Corrections on the Results of European Regional GNSS Network

Department of Geodesy and Geodetic Astronomy Warsaw University of Technology, Poland

Artificial Satellites

In the paper I investigated the effect of the GLONASS-specific receiver antenna phase center corrections on the results of a regional permanent GNSS network. I...

Effect of the Glonass-Specific Receiver Antenna Phase Center Corrections on the Results of European Regional GNSS Network

Publicado en línea: 04 dic 2013

Páginas: 191 - 203

DOI: https://doi.org/10.2478/v10018-013-0016

This content is open access.