<abstract xmlns="http://www.w3.org/1999/xhtml"><p>This paper focuses on the setup of axial bearing capacity of open ended tubular steel piles that are used for offshore foundation systems such as those of wind turbines. A comparative evaluation of the most commonly used models for setup prediction shows an upper estimate bound and a lower estimate bound, which correspond approximately to a setup rate of 60% increase per log cycle of time and 20% increase per log cycle of time, respectively. This finding is validated with the results of case histories reported in literature, which show that the setup values of most case histories considered lie in the best estimate zone between the upper estimate zone and the lower estimate zone. The analysis results show a minimum setup factor of approximately 1.5 for 100 days following end of driving of open-ended tubular steel pile driven in sand.</p></abstract>

This paper focuses on the setup of axial bearing capacity of open ended tubular steel piles that are used for offshore foundation systems such as those of wind turbines. A comparative evaluation of the most commonly used models for setup prediction shows an upper estimate bound and a lower estimate bound, which correspond approximately to a setup rate of 60% increase per log cycle of time and 20% increase per log cycle of time, respectively. This finding is validated with the results of case histories reported in literature, which show that the setup values of most case histories considered lie in the best estimate zone between the upper estimate zone and the lower estimate zone. The analysis results show a minimum setup factor of approximately 1.5 for 100 days following end of driving of open-ended tubular steel pile driven in sand.

Setup of axial bearing capacity of open ended tubular steel piles driven in sand

National University of Sciences, Technologies, Engineering and Mathematics (UNSTIM)

Studia Geotechnica et Mechanica

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

{"article-title":"Setup of axial bearing capacity of open ended tubular steel piles driven in sand"}

This paper focuses on the setup of axial bearing capacity of open ended tubular steel piles that are used for offshore foundation systems such as those of wind...

Setup of axial bearing capacity of open ended tubular steel piles driven in sand

Article Category: Research Article

Publicado en línea: 19 mar 2020

Páginas: 74 - 82

Recibido: 24 abr 2019

Aceptado: 18 sept 2019

DOI: https://doi.org/10.2478/sgem-2019-0032

Palabras clave
Setup, axial bearing capacity, driven open ended pile, granular soil, sand

© 2020 Marx Ferdinand Ahlinhan et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

Setup of axial bearing capacity of open ended tubular steel piles driven in sand

Article Category: Research Article

Publicado en línea: 19 mar 2020

Páginas: 74 - 82

Recibido: 24 abr 2019

Aceptado: 18 sept 2019

DOI: https://doi.org/10.2478/sgem-2019-0032

Palabras claveSetup, axial bearing capacity, driven open ended pile, granular soil, sand

© 2020 Marx Ferdinand Ahlinhan et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

Palabras clave
Setup, axial bearing capacity, driven open ended pile, granular soil, sand