<abstract xmlns="http://www.w3.org/1999/xhtml">The electrochemical impedance spectroscopy (EIS) and corrosion behaviour of physical vapour deposited (PVD) TiAlN and TiCN coatings of 50 µm mesh shaped AISI 316 stainless steel were estimated under simulated marine conditions (3.5 wt. % NaCl solution). The coatings were prepared by creating adhesive Cr-CrN interlayer with the thickness of about 0.3 µm. The obtained thicknesses of produced coatings were measured to be in a range between 2 and 3.5 µm. The presence of protective coatings leads to corrosion potential (<italic>Ecorr</italic>) shifting to more positive values as compared to the bare stainless steel. This effect indicates higher protection efficiency of coated steel under marine conditions. The protective behaviour of produced coating leads to the decreased corrosion current density (<italic>jcorr</italic>) by indicating up to 40-fold higher polarization resistance as compared to resistance of the naturally formed oxide layer over the stainless steel. The Nyquist and Bode plots were obtained with the help of EIS measurements by applying alternating potential amplitude of 10 mV on observed <italic>Ecorr</italic>. The obtained plots were fitted by appropriate equivalent circuits to calculate pore resistance, charge transfer resistance and capacitance. The present study reveals that pore resistance was the highest in the case of TiCN coating (<italic>Rpore</italic>=3.22 kΩ·cm2). The increase in duration of the immersion up to 24 h leads to change in the capacitive behaviour of the coatings caused by the penetration of the aqueous solution into pore system of TiCN coating with low wettability and surface passivation of reactive TiAlN coating. The presence of defects was confirmed by examining the obtained samples with the help of the scanning electron microscope.</abstract>

The electrochemical impedance spectroscopy (EIS) and corrosion behaviour of physical vapour deposited (PVD) TiAlN and TiCN coatings of 50 µm mesh shaped AISI 316 stainless steel were estimated under simulated marine conditions (3.5 wt. % NaCl solution). The coatings were prepared by creating adhesive Cr-CrN interlayer with the thickness of about 0.3 µm. The obtained thicknesses of produced coatings were measured to be in a range between 2 and 3.5 µm. The presence of protective coatings leads to corrosion potential (Ecorr) shifting to more positive values as compared to the bare stainless steel. This effect indicates higher protection efficiency of coated steel under marine conditions. The protective behaviour of produced coating leads to the decreased corrosion current density (jcorr) by indicating up to 40-fold higher polarization resistance as compared to resistance of the naturally formed oxide layer over the stainless steel. The Nyquist and Bode plots were obtained with the help of EIS measurements by applying alternating potential amplitude of 10 mV on observed Ecorr. The obtained plots were fitted by appropriate equivalent circuits to calculate pore resistance, charge transfer resistance and capacitance. The present study reveals that pore resistance was the highest in the case of TiCN coating (Rpore=3.22 kΩ·cm2). The increase in duration of the immersion up to 24 h leads to change in the capacitive behaviour of the coatings caused by the penetration of the aqueous solution into pore system of TiCN coating with low wettability and surface passivation of reactive TiAlN coating. The presence of defects was confirmed by examining the obtained samples with the help of the scanning electron microscope.

Corrosion and Electrochemical Impedance Spectroscopy of Thin TiALN and TiCN PVD Coatings for Protection of Ballast Water Screen Filters

Latvian Journal of Physics and Technical Sciences

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

The electrochemical impedance spectroscopy (EIS) and corrosion behaviour of physical vapour deposited (PVD) TiAlN and TiCN coatings of 50 µm mesh shaped AISI...

Corrosion and Electrochemical Impedance Spectroscopy of Thin TiALN and TiCN PVD Coatings for Protection of Ballast Water Screen Filters

Publicado en línea: 30 mar 2021

Páginas: 64 - 78

DOI: https://doi.org/10.2478/lpts-2021-0012

Palabras clave
Coatings, corrosion, electrochemical impedance spectroscopy, marine conditions, protection, PVD

© 2021 R. Kalnina et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Corrosion and Electrochemical Impedance Spectroscopy of Thin TiALN and TiCN PVD Coatings for Protection of Ballast Water Screen Filters

Publicado en línea: 30 mar 2021

Páginas: 64 - 78

DOI: https://doi.org/10.2478/lpts-2021-0012

Palabras claveCoatings, corrosion, electrochemical impedance spectroscopy, marine conditions, protection, PVD

© 2021 R. Kalnina et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Palabras clave
Coatings, corrosion, electrochemical impedance spectroscopy, marine conditions, protection, PVD