The identification of honey bee (
Most differences among honey bee subspecies are determined genetically (Węgrzynowicz et al., 2019), but honey bee wing venation is also known to be affected by multiple environmental factors including
Seasonal variability of wing venation can affect the identification of honey bee subspecies. The cubital index has been shown to vary seasonally between 2% (Gromisz, 1962) and 27% (Nazzi, 1992) and also wing size expressed as wing width and length or vein lengths (Gromisz, 1962; Nazzi, 1992). A similar variation in wing size and shape was also found in
The aim of this study was to investigate how seasonal changes in wing venation affect the identification of honey bee lineages based on the methods of geometric morphometrics. Moreover, results of the identification based on the left and right wings were compared. Improved knowledge of the seasonal variation of forewing venation can help to assess the precision of the measurements and their interpretation.
In this study, four colonies located in Garlica Murowana, Poland (latitude and longitude: 50.14, 19.93) were used. All colonies were under normal beekeeping practices involving inspections and honey harvesting. The investigated colonies were not obtained from honey bee queen breeders but were randomly chosen among managed colonies used for beekeeping. None of the colonies showed any symptoms of diseases other than
Both left and right forewings were dissected and mounted in diapositive frames (Rowi 260) between two pieces of glass. They were scanned using a Nikon SUPER COOLSCAN 5000 ED scanner equipped with a Nikon SF-210 slide feeder. The resolution of the images was 4000 dots per inch (image size: 5782x3946 pixels). In the forewing images, nineteen characteristic points called homologous landmarks were marked (Fig. 1, for details see Nawrocka et al., 2017). All the landmarks corresponded to type I landmarks (sensu Bookstein 1991) except for landmark 19 which was a type III. The landmarks were aligned using the Generalized Procrustes Analysis (Dryden & Mardia, 1998) in MorphoJ v. 1.06c software (Klingenberg, 2011). Both the left and right forewings were measured in this way. The aligned coordinates of the landmarks were used to describe the wing shape. The natural logarithm of centroid size (CS) was used to describe the wing size. Differences in wing shape were measured as the Procrustes distance.
Schematic of forewing of honey bee worker with landmarks marked as black dots and numbers.
Differences in wing size were analyzed with a three-way analysis of variance (ANOVA) with colony, month and body side as independent variables (factors). Differences in wing shape were analyzed with a three-way multivariate analysis of covariance (MANCOVA) with CS used as covariate and the same independent variables as in the previous analysis. In order to test how differences between months and body sides affect identification, we used IdentiFly software. Every colony was classified as one of the four lineages of the honey bee: A, C, M and O. Lineages were identified instead of subspecies because the available reference samples were large and would provide more reliable results.
Forewing size (measured by CS) differed significantly among colonies, months and sides (Tab. 1). The largest differences in forewing size were between colonies and the means of the CS (±SD) in our analyzed colonies (A, B, C and D) were 6.469±0.016, 6.490±0.019, 6.488±0.011 and 6.479±0.017, respectively. CS differed less between the months June, July, August and September and was 6.478±0.017, 6.486±0.017, 6.484±0.018, 6.478±0.018, respectively. The smallest differences in forewing size were observed between sides, and the mean CS of the left and right forewing was 6.480±0.018 and 6.483±0.018, respectively. There was also significant interaction between the factors of colony and month (Tab. 1), which indicated that the pattern of forewing size changes in consecutive months differed among colonies. In two colonies, maximum forewing size was achieved in July and in the other two in August (Fig. 2). Other interactions were not significant (Tab. 1). The multivariate analysis of covariance revealed that there was a significant allometric relationship between wing shape and size (Tab. 2, effect of size). The percent of the wing shape variance explained by size for combined data was 2.11%. Wing shape differed among colonies and months but not between sides (Tab. 2). The largest difference in wing shape, measured by the Procrustes distance, was 0.0190 and occurred between colonies C and D. The largest difference in wing shape between two months was 0.0062 and occurred between August and September. The difference in shape between left and right forewings was 0.0027. There was a complicated pattern of interaction between colony, month and centroid size (Tab. 2).
Differences in wing size analyzed by three way analysis of variance
Effect | df | MS | F | p |
---|---|---|---|---|
colony | 3 | 5894 | 58 | 0.000000 |
month | 3 | 1084 | 11 | 0.000001 |
side | 1 | 421 | 4 | 0.043060 |
colony*month | 9 | 755 | 7 | 0.000000 |
coony*side | 3 | 16 | 0 | 0.926473 |
month*side | 3 | 6 | 0 | 0.983432 |
colony*month*side | 9 | 14 | 0 | 0.998740 |
Mean logarithm of centroid size ± 95% confidence intervals (CI) in four honey bee colonies during four months.
Differences in wing shape analyzed by multivariate analysis of covariance (MANCOVA) with wing size used as covariate
Effect | Wilks Λ | F | p |
---|---|---|---|
colony | 0.562513 | 3.273041 | 0.000000 |
month | 0.729034 | 1.719851 | 0.000020 |
side | 0.979761 | 0.319570 | 0.999931 |
size | 0.738690 | 5.472685 | 0.000000 |
colony*month | 0.392991 | 1.702865 | 0.000000 |
colony*side | 0.900845 | 0.548305 | 0.999919 |
month*side | 0.908418 | 0.503640 | 0.999990 |
colony*size | 0.570564 | 3.184397 | 0.000000 |
month*size | 0.729804 | 1.713796 | 0.000023 |
side*size | 0.979607 | 0.322057 | 0.999925 |
colony*month*side | 0.728981 | 0.556043 | 1.000000 |
colony*month*size | 0.393136 | 1.702155 | 0.000000 |
colony*side*size | 0.901142 | 0.546541 | 0.999925 |
month*side*size | 0.908748 | 0.501705 | 0.999991 |
colony*month*side*size | 0.729055 | 0.555861 | 1.000000 |
Using the wing shape of workers from different months for the identification of honey bee lineage resulted in some varied results (Fig. 3A). However, this variation did not affect the final conclusion of the identification. In all consecutive months, colonies A, B, C and D were classified as lineages A, C, A and O, respectively. Variation in the results related to the left or right forewing was smaller (Fig. 3B) and did not affect the lineage identification, which was the same as in the case of different months.
Discrimination of honey bee lineages based on the first two canonical variates obtained with IdentiFly software. Colonies A, B, C and D were indicated with circles, squares, diamonds and triangles, respectively. In graph A, June, July, August and September were indicated with blue, red, green and black, respectively. In graph B, the left and right body sides were indicated with red and black, respectively.
The results presented here show that the statistically significant differences among forewings collected in different months are relatively small in comparison to differences among colonies. In some circumstances, when a colony is a hybrid of two subspecies, those small differences can lead to different conclusions. This should be taken into account when the results of identification are interpreted. Not only should it be recorded which reference group is most similar to the analyzed sample, but also the similarity to different groups should be analyzed. If the probability of identification is similar in the case of two or more groups, then another measurement performed at a different time can lead to the conclusion that the most similar group is different.
All the investigated colonies should be considered as hybrids, but they were classified to the most similar lineage. Only one colony was most similar to lineage C, which is native to the study location. Other colonies were most similar either to lineage A or O. The presence of non native bees is related to the importation of genetic material by honey bee queen breeders and massive production of queens. Bees from lineage A were used to obtain hybrids distributed as Buckfast breeding line. The presence of lineage O is probably related to the import of
The monthly variation of wing shape was significant, but it occurred in an unpredictable way between colonies and months. This unpredictability was possibly related to hybridization and different genetic background of the investigated colonies. The monthly variation among related colonies from the same subspecies could be more consistent. The workers of our hybridized colonies from early summer cannot be predicted to be more similar to any of the lineages than workers from later summer. The monthly variation makes identification less precise, but it is difficult to recommend in which month the samples should be collected. In contrast to seasonal variation, there were no significant differences in wing shape between the left and right forewings.
The seasonal variation of forewing shape observed here is consistent to some degree with earlier studies, which were based on the cubital index or venation angles. Gromisz (1962) determined that the cubital index did not differ significantly between months, but Nazzi (1992) concluded that there were large and significant seasonal differences. In the latter study, the cubital index variation was particularly large earlier in the season. In all of those studies, the value of the cubital index varied unpredictably over the course of the year. The large variation of the indexes used in traditional morphometry suggests that geometric morphometrics based on landmarks is more suitable for the description of wing shape.
If differences among subspecies are relatively large, for example when they belong to different lineages, then they can be successfully discriminated using wing shape (Francoy et al., 2008; Tofilski, 2008; Barour & Baylac, 2016). In those cases, seasonal variation is less likely to affect the discrimination. However, if differences between subspecies are smaller their discrimination based on wing shape is less successful (Kandemir et al., 2011; Nawrocka et al., 2017) and seasonal variation can be an important factor.
In comparison to wing shape, the seasonal variation of wing size is more predictable. Although there are some differences between colonies (Fig. 2), the wing size tends to be largest in the middle of the summer. These results agree with those of an earlier study conducted by Gromisz (1962) in a similar climate. Nazzi (1992) conducted another study in a Mediterranean climate and reported that the wing size variation seemed to be different. The main factor affecting wing size is possibly food availability, which differs among locations and years. In the climatic conditions of this study site, vegetation starts to develop in March and April but most plants important as food sources flower in May and June. The availability of pollen and nectar gradually decreases in July, August and September. Another factor which could affect monthly variation of wing size is
Wing size is effected by the environmental factors more than shape, and therefore, using it for discrimination between subspecies or lineages may be risky, even if it increases slightly the success of the discrimination of a particular dataset (Barour & Baylac, 2016). Moreover, there is a significant relationship between size and shape (Tab. 2, effect of size), and it is difficult to make the discrimination completely independent of size. Fortunately, the percentage of shape variance explained by size is relatively small.
We also found significant differences in wing size between the left and right body sides, which is often called directional asymmetry of wing size. This confirms earlier studies by Smith et al. (1997), Schneider et al. (2003) and Łopuch & Tofilski (2016). In all cases, the right forewings were larger than the left ones, although the significance of the differences in size between body sides was small in comparison to differences between colonies.
The results presented here show that forewing shape and size are not only determined genetically but also depend on many environmental factors. Those factors should be taken into account when planning wing measurements and interpreting their results.