<abstract xmlns="http://www.w3.org/1999/xhtml">

The applicability of the single-aliquot regenerative-dose (SAR) protocol, by using the optically stimulated luminescence (OSL) signal of quartz as well as the post-infrared–infrared (pIRIR) signals of polymineral fine grains, namely pIRIR225 and pIRIR290, was assessed for dating loess in New Zealand South Island. OSL signals of quartz grains displayed low sensitivity. However, the application of repeated irradiation/bleaching cycles did not result in an increase in sensitivity; annealing in the 300–500°C temperature range generated the sensitisation of both the 110°C thermoluminescence (TL) peak as well as the OSL signal, likely by activation of yet unidentified luminescence centres. After heating, the quartz signal is comparable to that of ideal samples, but the annealing is precluding successful dating. On the other hand, feldspar infrared-stimulated signals displayed satisfactory properties, allowing estimation of ages ranging from 14 ± 1–29 ± 3 ka for the investigated deposit. It was shown that pIRIR225 and pIRIR290 methods have potential for dating loess in the South Island of New Zealand, based on the following observations: (i) Dose recovery tests were successful with recovered-to-given dose ratios with a &lt;10% deviation from unity, (ii) constant residual values of about 4 Gy and about 10 Gy were obtained after exposures for 48 h in the case of pIRIR225 signals and 96 h in the case of pIRIR290 signals, respectively, (iii) while a slight dose-dependence of the residual was reported, and for a dose as large as 1600 Gy the residual values are ≅9 Gy and ≅19 Gy for pIRIR225 and pIRIR290 signals, respectively.
</abstract>

The applicability of the single-aliquot regenerative-dose (SAR) protocol, by using the optically stimulated luminescence (OSL) signal of quartz as well as the post-infrared–infrared (pIRIR) signals of polymineral fine grains, namely pIRIR225 and pIRIR290, was assessed for dating loess in New Zealand South Island. OSL signals of quartz grains displayed low sensitivity. However, the application of repeated irradiation/bleaching cycles did not result in an increase in sensitivity; annealing in the 300–500°C temperature range generated the sensitisation of both the 110°C thermoluminescence (TL) peak as well as the OSL signal, likely by activation of yet unidentified luminescence centres. After heating, the quartz signal is comparable to that of ideal samples, but the annealing is precluding successful dating. On the other hand, feldspar infrared-stimulated signals displayed satisfactory properties, allowing estimation of ages ranging from 14 ± 1–29 ± 3 ka for the investigated deposit. It was shown that pIRIR225 and pIRIR290 methods have potential for dating loess in the South Island of New Zealand, based on the following observations: (i) Dose recovery tests were successful with recovered-to-given dose ratios with a <10% deviation from unity, (ii) constant residual values of about 4 Gy and about 10 Gy were obtained after exposures for 48 h in the case of pIRIR225 signals and 96 h in the case of pIRIR290 signals, respectively, (iii) while a slight dose-dependence of the residual was reported, and for a dose as large as 1600 Gy the residual values are ≅9 Gy and ≅19 Gy for pIRIR225 and pIRIR290 signals, respectively.

Investigations on the Luminescence Properties of Quartz and Feldspars Extracted from Loess in the Canterbury Plains, New Zealand South Island

Faculty of Environmental Science and Engineering

Interdisciplinary Research Institute on Bio-Nano-Sciences, Environmental Radioactivity and Nuclear Dating Centre

Marine Geology & Seafloor Surveying, Department of Geosciences

RDI Laboratory of Applied Raman Spectroscopy

Geochronometria

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

The applicability of the single-aliquot regenerative-dose (SAR) protocol, by using the optically stimulated luminescence (OSL) signal of quartz as well as the...

Investigations on the Luminescence Properties of Quartz and Feldspars Extracted from Loess in the Canterbury Plains, New Zealand South Island

Publicado en línea: 30 abr 2021

Páginas: 46 - 60

Recibido: 30 sept 2020

Aceptado: 18 mar 2021

DOI: https://doi.org/10.2478/geochr-2021-0005

Palabras clave
quartz, feldspar, luminescence, sensitivity, loess, New Zealand

© 2021 D. Brezeanu et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Investigations on the Luminescence Properties of Quartz and Feldspars Extracted from Loess in the Canterbury Plains, New Zealand South Island

Publicado en línea: 30 abr 2021

Páginas: 46 - 60

Recibido: 30 sept 2020

Aceptado: 18 mar 2021

DOI: https://doi.org/10.2478/geochr-2021-0005

Palabras clavequartz, feldspar, luminescence, sensitivity, loess, New Zealand

© 2021 D. Brezeanu et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Palabras clave
quartz, feldspar, luminescence, sensitivity, loess, New Zealand