Influence of the Print Layer Height in FDM Technology on the Rolling Force Value and the Print Time
Wojciech Kiński
Department of Mechanics and Basics of Machine Construction, University of Warmia and Mazury in Olsztyn
Perfil de OrcidBuscar este autor en
y Paweł Pietkiewicz
Department of Mechanics and Basics of Machine Construction, University of Warmia and Mazury in Olsztyn
Perfil de OrcidBuscar este autor en
31 dic 2019
Acerca de este artículo
Publicado en línea: 31 dic 2019
Páginas: 1 - 9
Recibido: 01 sept 2019
Aceptado: 01 dic 2019
DOI: https://doi.org/10.1515/agriceng-2019-0031
Palabras clave
© 2019 Wojciech Kiński et al., published by Sciendo
This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.
Kiński, Wojciech
Department of Mechanics and Basics of Machine Construction, University of Warmia and Mazury in Olsztyn
Pietkiewicz, Paweł
Department of Mechanics and Basics of Machine Construction, University of Warmia and Mazury in Olsztyn