<abstract xmlns="http://www.w3.org/1999/xhtml"><p>The paper presents a study on microstructure and microhardness changes obtained in the spun carbon steel tube after shaping by a laser beam. The surface of a pipe was machined circumferentially using a 1500 W CO<sub>2</sub> laser beam at various diameters (distance from the focus). As a result, plastic deformations such as convex and narrowing shape changes were observed. The conducted research, including microhardness measurements, shows that, in comparison to the unprocessed material, the microstructure was significantly changed, both in the convex and narrowed layer.</p></abstract>

The paper presents a study on microstructure and microhardness changes obtained in the spun carbon steel tube after shaping by a laser beam. The surface of a pipe was machined circumferentially using a 1500 W CO2 laser beam at various diameters (distance from the focus). As a result, plastic deformations such as convex and narrowing shape changes were observed. The conducted research, including microhardness measurements, shows that, in comparison to the unprocessed material, the microstructure was significantly changed, both in the convex and narrowed layer.

Laser Forming of Steel Tubes

Faculty of Mechatronics and Mechanical Engineering

Technical Transactions

This work is licensed under the Creative Commons Attribution-ShareAlike 4.0 Public License.

{"article-title":"Laser Forming of Steel Tubes"}

The paper presents a study on microstructure and microhardness changes obtained in the spun carbon steel tube after shaping by a laser beam. The surface of a...

Laser Forming of Steel Tubes

Online veröffentlicht: 16. Mai 2020

Seitenbereich: 223 - 229

Eingereicht: 21. Dez. 2018

DOI: https://doi.org/10.4467/2353737XCT.19.015.10055

Schlüsselwörter
laser forming, tube, carbon steel

© 2020 Norbert Radek et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-ShareAlike 4.0 Public License.

Laser Forming of Steel Tubes

Online veröffentlicht: 16. Mai 2020

Seitenbereich: 223 - 229

Eingereicht: 21. Dez. 2018

DOI: https://doi.org/10.4467/2353737XCT.19.015.10055

Schlüsselwörterlaser forming, tube, carbon steel

© 2020 Norbert Radek et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-ShareAlike 4.0 Public License.

Schlüsselwörter
laser forming, tube, carbon steel