<abstract xmlns="http://www.w3.org/1999/xhtml"><p>This paper shows a parameters selection method providing an ablative laser treatment removal of materials. A laser for generating laser beams of ultraviolet light in picosecond pulses at a frequency to 400 kHz was used in the experiment. The quality of the marks was examined by scanning electron microscopy. On the basis of the analysis, it is recommended to conduct micromachining at a frequency of 100 kHz and exposure times within the range of 62.5 ms to 125 ms.</p></abstract>

This paper shows a parameters selection method providing an ablative laser treatment removal of materials. A laser for generating laser beams of ultraviolet light in picosecond pulses at a frequency to 400 kHz was used in the experiment. The quality of the marks was examined by scanning electron microscopy. On the basis of the analysis, it is recommended to conduct micromachining at a frequency of 100 kHz and exposure times within the range of 62.5 ms to 125 ms.

Selection of parameters for laser surface texturing of titanium alloys

Fundamentals of Technology Chair, Faculty of Production Engineering

Centre for Laser Technology of Metals, Faculty of Mechatronics and Machine Design

Department of Materials Engineering, Faculty of Mechanical Engineering

Technical Transactions

This work is licensed under the Creative Commons Attribution-ShareAlike 4.0 Public License.

{"article-title":"Selection of parameters for laser surface texturing of titanium alloys"}

This paper shows a parameters selection method providing an ablative laser treatment removal of materials. A laser for generating laser beams of ultraviolet...

Selection of parameters for laser surface texturing of titanium alloys

Online veröffentlicht: 23. Mai 2020

Seitenbereich: 167 - 171

Eingereicht: 13. Nov. 2018

DOI: https://doi.org/10.4467/2353737XCT.18.189.9677

Schlüsselwörter
laser surface texturing, titanium alloys

© 2018 Monika Krzywicka et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-ShareAlike 4.0 Public License.

Selection of parameters for laser surface texturing of titanium alloys

Online veröffentlicht: 23. Mai 2020

Seitenbereich: 167 - 171

Eingereicht: 13. Nov. 2018

DOI: https://doi.org/10.4467/2353737XCT.18.189.9677

Schlüsselwörterlaser surface texturing, titanium alloys

© 2018 Monika Krzywicka et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-ShareAlike 4.0 Public License.

Schlüsselwörter
laser surface texturing, titanium alloys