<abstract xml:lang="en" xmlns="http://www.w3.org/1999/xhtml"><p>The paper brings results of the surface layers properties analysis of a thin wall hollow sheet metal parts, produced by metal spinning and deep drawing. The influence of mandrel (workpiece) frequency of rotation on the spun parts surface layer strainhardening is studied and compared with the quality of the formed part surface layer produced by deep drawing technology.</p></abstract>

The paper brings results of the surface layers properties analysis of a thin wall hollow sheet metal parts, produced by metal spinning and deep drawing. The influence of mandrel (workpiece) frequency of rotation on the spun parts surface layer strainhardening is studied and compared with the quality of the formed part surface layer produced by deep drawing technology.

Analysing the Properties of Surface Layers Generated by Sheet Metal Forming Operations

Institute of Production Technologies, Faculty of Materials Science and Technology in Trnava, Slovak University of Technology Bratislava, J. Bottu 25, 917 24 Trnava, Slovak Republic

Research Papers Faculty of Materials Science and Technology Slovak University of Technology

The paper brings results of the surface layers properties analysis of a thin wall hollow sheet metal parts, produced by metal spinning and deep drawing. The...

Analysing the Properties of Surface Layers Generated by Sheet Metal Forming Operations

Online veröffentlicht: 03. März 2011

Seitenbereich: 39 - 45

DOI: https://doi.org/10.2478/v10186-010-0024-0

Schlüsselwörter
surface layer, strainhardening, metal spinning, microhardness

This content is open access.

Analysing the Properties of Surface Layers Generated by Sheet Metal Forming Operations

Online veröffentlicht: 03. März 2011

Seitenbereich: 39 - 45

DOI: https://doi.org/10.2478/v10186-010-0024-0

Schlüsselwörtersurface layer, strainhardening, metal spinning, microhardness

This content is open access.

Schlüsselwörter
surface layer, strainhardening, metal spinning, microhardness