<abstract xmlns="http://www.w3.org/1999/xhtml"><p>The article presents back analysis to estimate geotechnical parameters of fill layer. The agreement between field measurements and theoretical calculations was examined. Displacements of a cantilever CFA bored pile wall were monitored. The inclinometric measurements were taken directly after pile construction and according to excavation process. Over 200 calculation series were performed, with changing fill parameters. The calculations employed the actual geometric and material parameters of the pile wall, as well as geotechnical parameters of layered soil. The parameters estimated through back analysis were the angle of internal friction and Young’s modulus of fill layer. In the case discussed, pile wall cap displacement was the response of the system, and soil medium parameters were the input data. The agreement between theoretical calculations and inclinometer measurements was assessed in accordance with two functions. The measured horizontal displacements of excavation support structure assumed different values at the two inclinometer sites analysed. Back analysis results for these sites are approximately convergent for a final excavation depth.</p></abstract>

The article presents back analysis to estimate geotechnical parameters of fill layer. The agreement between field measurements and theoretical calculations was examined. Displacements of a cantilever CFA bored pile wall were monitored. The inclinometric measurements were taken directly after pile construction and according to excavation process. Over 200 calculation series were performed, with changing fill parameters. The calculations employed the actual geometric and material parameters of the pile wall, as well as geotechnical parameters of layered soil. The parameters estimated through back analysis were the angle of internal friction and Young’s modulus of fill layer. In the case discussed, pile wall cap displacement was the response of the system, and soil medium parameters were the input data. The agreement between theoretical calculations and inclinometer measurements was assessed in accordance with two functions. The measured horizontal displacements of excavation support structure assumed different values at the two inclinometer sites analysed. Back analysis results for these sites are approximately convergent for a final excavation depth.

Analysis of displacement of excavation based on inclinometer measurements

Wrocław University of Technology, Faculty of Civil Engineering, Institute of Geotechnics and Hydroengineering, Department of Engineering Foundations, Wybrzeże Wyspiańskiego 27, 50-370 Wrocław, Poland

Studia Geotechnica et Mechanica

{"article-title":"Analysis of displacement of excavation based on inclinometer measurements"}

The article presents back analysis to estimate geotechnical parameters of fill layer. The agreement between field measurements and theoretical calculations was...

Analysis of displacement of excavation based on inclinometer measurements

Online veröffentlicht: 09. Nov. 2012

Seitenbereich: 3 - 16

DOI: https://doi.org/10.2478/sgm041201

This content is open access.