<abstract xmlns="http://www.w3.org/1999/xhtml"><p>The stress distribution in specimens designed for the tensile testing is evaluated in the article. The reinforcement consists of long fibers that copy the outer contour of the specimen. The fibers are inserted within the curvature at the edge of the specimen with the neck. The stress distribution in fibers and matrix of dogbone specimen and specimen of rectangular shape is analyzed and compared. The analysis of stress state is analyzed in FEM software ADINA. Long fibers deposited in specimen were modeled using rebar elements.</p></abstract>

The stress distribution in specimens designed for the tensile testing is evaluated in the article. The reinforcement consists of long fibers that copy the outer contour of the specimen. The fibers are inserted within the curvature at the edge of the specimen with the neck. The stress distribution in fibers and matrix of dogbone specimen and specimen of rectangular shape is analyzed and compared. The analysis of stress state is analyzed in FEM software ADINA. Long fibers deposited in specimen were modeled using rebar elements.

Influence of the Shape of the Test Specimen Produced by 3D Printing on the Stress Distribution in the Matrix and in Long Reinforcing Fibers

Faculty of Mechanical Engineering, Department of Applied Mechanics

Strojnícky časopis - Journal of Mechanical Engineering

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

The stress distribution in specimens designed for the tensile testing is evaluated in the article. The reinforcement consists of long fibers that copy the...

Influence of the Shape of the Test Specimen Produced by 3D Printing on the Stress Distribution in the Matrix and in Long Reinforcing Fibers

Online veröffentlicht: 15. Nov. 2019

Seitenbereich: 61 - 68

DOI: https://doi.org/10.2478/scjme-2019-0030

Schlüsselwörter
carbon fiber, reinforced composite, tensile test, 3D printing, ADINA, FE analysis, MATLAB

© 2019 Handrik Marián et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Influence of the Shape of the Test Specimen Produced by 3D Printing on the Stress Distribution in the Matrix and in Long Reinforcing Fibers

Online veröffentlicht: 15. Nov. 2019

Seitenbereich: 61 - 68

DOI: https://doi.org/10.2478/scjme-2019-0030

Schlüsselwörtercarbon fiber, reinforced composite, tensile test, 3D printing, ADINA, FE analysis, MATLAB

© 2019 Handrik Marián et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Schlüsselwörter
carbon fiber, reinforced composite, tensile test, 3D printing, ADINA, FE analysis, MATLAB