<abstract xmlns="http://www.w3.org/1999/xhtml">

<p>This article provides information about comparative research on designing of spinning trajectories for products with a non-circular cross-section. Generation of two outlines for the two mandrels was carried out using three methods: (1) a spreadsheet, (2) a 2D CAD program, and (3) a 3D CAD program. Technological tests were carried out using mandrels with the following geometries: ellipse and square. The material used in the research was aluminum Al 1050A. Due to the high degree of complexity in the design of the trajectory, Method 1 was used only for spinning of the ellipse. Methods 2 and 3 were used for spinning the square. Only Method 3 was suitable for programming of upsetting moves of tool. Test of Vickers's microhardness was conducted on sample 3. The influence of the spinning trajectory on the drawpiece was evaluated by measuring the percentage reduction of side wall thickness.</p>
</abstract>

This article provides information about comparative research on designing of spinning trajectories for products with a non-circular cross-section. Generation of two outlines for the two mandrels was carried out using three methods: (1) a spreadsheet, (2) a 2D CAD program, and (3) a 3D CAD program. Technological tests were carried out using mandrels with the following geometries: ellipse and square. The material used in the research was aluminum Al 1050A. Due to the high degree of complexity in the design of the trajectory, Method 1 was used only for spinning of the ellipse. Methods 2 and 3 were used for spinning the square. Only Method 3 was suitable for programming of upsetting moves of tool. Test of Vickers's microhardness was conducted on sample 3. The influence of the spinning trajectory on the drawpiece was evaluated by measuring the percentage reduction of side wall thickness.

Comparison of spinning trajectory designing methods for products with noncircular cross-section

Institute of Materials Science and Engineering, Faculty of Mechanical Engineering

Materials Science-Poland

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

This article provides information about comparative research on designing of spinning trajectories for products with a non-circular cross-section. Generation...

Comparison of spinning trajectory designing methods for products with noncircular cross-section

Online veröffentlicht: 13. Juli 2022

Seitenbereich: 116 - 129

Eingereicht: 11. Feb. 2022

Akzeptiert: 20. Mai 2022

DOI: https://doi.org/10.2478/msp-2022-0012

Schlüsselwörter
metal spinning, noncircular spinning, asymmetric spinning, sheet metal

© 2022 Marcin Majewski et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Comparison of spinning trajectory designing methods for products with noncircular cross-section

Online veröffentlicht: 13. Juli 2022

Seitenbereich: 116 - 129

Eingereicht: 11. Feb. 2022

Akzeptiert: 20. Mai 2022

DOI: https://doi.org/10.2478/msp-2022-0012

Schlüsselwörtermetal spinning, noncircular spinning, asymmetric spinning, sheet metal

© 2022 Marcin Majewski et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Schlüsselwörter
metal spinning, noncircular spinning, asymmetric spinning, sheet metal