<abstract xmlns="http://www.w3.org/1999/xhtml">

In the initial position in the process of roll ginning, the seed is drawn to the slot of the contact gap of the knife-drum due to the tension of the fibers. Subsequently, the seed is struck with a certain impulse. The separation of the fibers from the seed after the impact of the beater occurs sequentially, not simultaneously.
As a result of theoretical and experimental studies, the optimum frequency of the shock pulse on the seed (<italic>f</italic> = 18-20) was found to be the most technologically successful in terms of providing the best quality indicators of seeds and fibers. Beating in the resonance mode allows to reduce the magnitude of the shock impulse on the seed, leading to a reduction in the degree of damage to the seeds. At this moment, the seeds at the end of the strand move only under the action of an elastic restoring force. The active part of the fiber bundle section in a dynamic process can be as little as 0.001 or less.
The average value of the compliance coefficient for the raw cotton variety BA-440 was determined experimentally. This allowed to determine the stiffness coefficient of the volatiles indirectly. According to the parameters obtained, the dynamic state of the system practically falls into the region of parametric resonance, where the motion is unstable. This means that the damaged seeds at the end of the strand enlarge significantly after the impact of the beater, causing the seeds to separate from the fibers.
</abstract>

In the initial position in the process of roll ginning, the seed is drawn to the slot of the contact gap of the knife-drum due to the tension of the fibers. Subsequently, the seed is struck with a certain impulse. The separation of the fibers from the seed after the impact of the beater occurs sequentially, not simultaneously.
As a result of theoretical and experimental studies, the optimum frequency of the shock pulse on the seed (f = 18-20) was found to be the most technologically successful in terms of providing the best quality indicators of seeds and fibers. Beating in the resonance mode allows to reduce the magnitude of the shock impulse on the seed, leading to a reduction in the degree of damage to the seeds. At this moment, the seeds at the end of the strand move only under the action of an elastic restoring force. The active part of the fiber bundle section in a dynamic process can be as little as 0.001 or less.
The average value of the compliance coefficient for the raw cotton variety BA-440 was determined experimentally. This allowed to determine the stiffness coefficient of the volatiles indirectly. According to the parameters obtained, the dynamic state of the system practically falls into the region of parametric resonance, where the motion is unstable. This means that the damaged seeds at the end of the strand enlarge significantly after the impact of the beater, causing the seeds to separate from the fibers.

Investigation of the Process of Separation of Fibers From Seeds During Roll Ginning

Azerbaijan State Economic University (UNEC)

Faculty of Engineering, Department of Engineering and Applied Sciences

Fibres & Textiles in Eastern Europe

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

In the initial position in the process of roll ginning, the seed is drawn to the slot of the contact gap of the knife-drum due to the tension of the fibers....

Investigation of the Process of Separation of Fibers From Seeds During Roll Ginning

Article Category: Research Article

Online veröffentlicht: 19. Apr. 2023

Seitenbereich: 91 - 94

DOI: https://doi.org/10.2478/ftee-2023-0010

Schlüsselwörter
knife-drum, cotton seeds, fiber strands, coefficient of elasticity, roller gin

© 2023 Łukasiewicz Research Network-Łódź Institute of Technology, published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Fig. 1.

Fig. 2.

Investigation of the Process of Separation of Fibers From Seeds During Roll Ginning

Article Category: Research Article

Online veröffentlicht: 19. Apr. 2023

Seitenbereich: 91 - 94

DOI: https://doi.org/10.2478/ftee-2023-0010

Schlüsselwörterknife-drum, cotton seeds, fiber strands, coefficient of elasticity, roller gin

© 2023 Łukasiewicz Research Network-Łódź Institute of Technology, published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Fig. 1.

Fig. 2.

Schlüsselwörter
knife-drum, cotton seeds, fiber strands, coefficient of elasticity, roller gin