<abstract xmlns="http://www.w3.org/1999/xhtml">

<p>The article presents the results of tests aimed at detecting discontinuities in the subsurface layer of elements intended for further processing. For the initial identification of discontinuities, the method of computed tomography was used. Based on the tomographic images of selected typical defects and measurements of the electrical conductivity of the material, the parameters for the eddy current tests were determined. A series of discontinuities in the subsurface layer to a depth of about 0.48 mm were detected. This allowed, at a given stage of machining, relevant elements to be selected for further processing.</p>
</abstract>

The article presents the results of tests aimed at detecting discontinuities in the subsurface layer of elements intended for further processing. For the initial identification of discontinuities, the method of computed tomography was used. Based on the tomographic images of selected typical defects and measurements of the electrical conductivity of the material, the parameters for the eddy current tests were determined. A series of discontinuities in the subsurface layer to a depth of about 0.48 mm were detected. This allowed, at a given stage of machining, relevant elements to be selected for further processing.

Detection of Sub-Surface Defects in Semi-Finished Products from Aluminum Alloys by the Eddy Current Method

Fatigue of Aircraft Structures

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

The article presents the results of tests aimed at detecting discontinuities in the subsurface layer of elements intended for further processing. For the...

Detection of Sub-Surface Defects in Semi-Finished Products from Aluminum Alloys by the Eddy Current Method

Online veröffentlicht: 28. Juli 2022

Seitenbereich: 31 - 39

DOI: https://doi.org/10.2478/fas-2021-0004

Schlüsselwörter
eddy current testing, tomographic testing, subsurface discontinuities, standard depth of penetration, effective depth of penetration

© 2021 Józef Krysztofik et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Detection of Sub-Surface Defects in Semi-Finished Products from Aluminum Alloys by the Eddy Current Method

Online veröffentlicht: 28. Juli 2022

Seitenbereich: 31 - 39

DOI: https://doi.org/10.2478/fas-2021-0004

Schlüsselwörtereddy current testing, tomographic testing, subsurface discontinuities, standard depth of penetration, effective depth of penetration

© 2021 Józef Krysztofik et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Schlüsselwörter
eddy current testing, tomographic testing, subsurface discontinuities, standard depth of penetration, effective depth of penetration