<abstract xmlns="http://www.w3.org/1999/xhtml"><p> Direct writing of low resistance wires on an amorphous Ge-Sb-Te matrix is reported. A 1342 nm continuous wave laser was used for local heating of the sample to form these wires. Mechanical contact was not needed for making the conducting elements. The properties of the samples were investigated down to 1.4 K and the laser conditions required for the writing of low resistance GST wires were found. The results are discussed with a view to possible applications, such as connectors and electrical wires made only via remote light exposure of the samples to make different resistors and non-linear elements</p></abstract>

Direct writing of low resistance wires on an amorphous Ge-Sb-Te matrix is reported. A 1342 nm continuous wave laser was used for local heating of the sample to form these wires. Mechanical contact was not needed for making the conducting elements. The properties of the samples were investigated down to 1.4 K and the laser conditions required for the writing of low resistance GST wires were found. The results are discussed with a view to possible applications, such as connectors and electrical wires made only via remote light exposure of the samples to make different resistors and non-linear elements

Noncontact Method of Conducting Elements “Writing” on Insulating Ge–Sb–Te Matrix Using a Laser Beam

Materials Science-Poland

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

Direct writing of low resistance wires on an amorphous Ge-Sb-Te matrix is reported. A 1342 nm continuous wave laser was used for local heating of the sample to...

Noncontact Method of Conducting Elements “Writing” on Insulating Ge–Sb–Te Matrix Using a Laser Beam

Online veröffentlicht: 25. Juni 2018

Seitenbereich: 217 - 224

Eingereicht: 18. Sept. 2017

Akzeptiert: 28. Jan. 2018

DOI: https://doi.org/10.1515/msp-2018-0012

Schlüsselwörter
GST, laser, conductor, noncontact method

© 2018 S. Khodorov et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

Noncontact Method of Conducting Elements “Writing” on Insulating Ge–Sb–Te Matrix Using a Laser Beam

Online veröffentlicht: 25. Juni 2018

Seitenbereich: 217 - 224

Eingereicht: 18. Sept. 2017

Akzeptiert: 28. Jan. 2018

DOI: https://doi.org/10.1515/msp-2018-0012

SchlüsselwörterGST, laser, conductor, noncontact method

© 2018 S. Khodorov et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

Schlüsselwörter
GST, laser, conductor, noncontact method