<abstract xmlns="http://www.w3.org/1999/xhtml"><p>In the work the analysis of existent methods of determination of local and general forces of cutting at polishing of surfaces with a type as the arc of circumference is given. The dependence for determination of speed polishing and method for determination of thickness of the cut away layer on condition of equality of the tricked into and taken off volumes of material are offered. The method of determination of cutting forces, which takes into account cutting and deforming grain, is suggested. The method of determining the thickness of a cutting layer of one of the cutting edge, from the condition that the volume of material that is brought and is cut in each local point of contact spots has been proposed. The proposed method takes into account the compliance of the processing system and the discontinuity of the abrasive surface of the tool. By experimental way upper limits of thickness cutting layer when using different abrasive materials for a wide range of cutting speeds have been obtained.</p></abstract>

In the work the analysis of existent methods of determination of local and general forces of cutting at polishing of surfaces with a type as the arc of circumference is given. The dependence for determination of speed polishing and method for determination of thickness of the cut away layer on condition of equality of the tricked into and taken off volumes of material are offered. The method of determination of cutting forces, which takes into account cutting and deforming grain, is suggested. The method of determining the thickness of a cutting layer of one of the cutting edge, from the condition that the volume of material that is brought and is cut in each local point of contact spots has been proposed. The proposed method takes into account the compliance of the processing system and the discontinuity of the abrasive surface of the tool. By experimental way upper limits of thickness cutting layer when using different abrasive materials for a wide range of cutting speeds have been obtained.

Determination of Cutting Forces in Grinding with Crossed Axes of Tool and Workpiece

Chernihiv National University of Technology, Mechanical Engineering Department, 95 Shevchenko street, Chernihiv,

Acta Mechanica et Automatica

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

In the work the analysis of existent methods of determination of local and general forces of cutting at polishing of surfaces with a type as the arc of...

Determination of Cutting Forces in Grinding with Crossed Axes of Tool and Workpiece

Online veröffentlicht: 04. Apr. 2017

Seitenbereich: 58 - 63

Eingereicht: 06. Mai 2016

Akzeptiert: 13. März 2017

DOI: https://doi.org/10.1515/ama-2017-0009

Schlüsselwörter
Cutting Forces, Grinding, Deforming Grain, Cutting Edge, Abrasive Surface, Abrasive Materials, Crossed Axes, Abrasive Grain, Cut Volumes, Grinding Wheel

© 2017 Bialystok University of Technology

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Determination of Cutting Forces in Grinding with Crossed Axes of Tool and Workpiece

Online veröffentlicht: 04. Apr. 2017

Seitenbereich: 58 - 63

Eingereicht: 06. Mai 2016

Akzeptiert: 13. März 2017

DOI: https://doi.org/10.1515/ama-2017-0009

SchlüsselwörterCutting Forces, Grinding, Deforming Grain, Cutting Edge, Abrasive Surface, Abrasive Materials, Crossed Axes, Abrasive Grain, Cut Volumes, Grinding Wheel

© 2017 Bialystok University of Technology

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Schlüsselwörter
Cutting Forces, Grinding, Deforming Grain, Cutting Edge, Abrasive Surface, Abrasive Materials, Crossed Axes, Abrasive Grain, Cut Volumes, Grinding Wheel