Sixteen volunteers each drank 700 ml sugar-containing soft drink during two successive periods and the blood sugar was measured at 10 min intervals together with electrical impedance spectroscopy and near infrared spectroscopy (NIR). A maximum correlation of 0.46 was found for the electrical measurements but no clear separation between low and high blood glucose levels were found in the NIR measurements. The latter was attributed to the experimental design where the NIR probe was removed from the skin between each measurement.
- near-infrared spectroscopy
The number of diabetes patients is increasing in numbers worldwide [1,2]. Even with adequate treatment and follow-up, morbidity and mortality is higher than in the general population [3,4,5,6]. To control blood glucose levels, patients may use the standard finger-prick method or one of the continuous blood glucose meters that have been developed over the later years . Non-invasive methods (not involving piercing the skin) for measuring blood glucose have been investigated for decades , but a working device with adequate accuracy does not exist today. A method for easy and pain-free blood glucose measurement would be revolutionary in the treatment of diabetes.
Sixteen test subjects participated in this study, eight female and eight male, mean age 24 (20–37) years. None of them suffered from diabetes or had health problems that were relevant for this study. They fasted overnight before partaking in the experiments.
The measurements were conducted in a laboratory with normal room temperature of around 22 °C. After a period of acclimatization (including information, informed consent, electrode attachment, etc.), their blood glucose was measured using a FreeStyle Freedome Lite device from Abbott Diabetes Care Ltd (Witney, UK).
Electrical impedance was then measured on the ventral side of the left underarm, using a frequency extended ISX-3 impedance analyzer from Sciospec Scientific Instruments GmbH (Bennewitz, Germany) and two KittyCat hydrogel electrodes (Kendall, KittyCat®, 1050NPSM) in a two-electrode system. One electrode was placed 2 cm below the elbow pit (antecubital fossa) and the other 10 cm further down the underarm towards the wrist. The measurements were done in the frequency range 100 Hz to 40 MHz using 400 mV p-p.
Near-infrared reflectometry was used on the same area of the right underarm using an Ocean Optics NIRQuest® 512 in the range 900 – 1700 nm (Ocean Insight, NY, USA).
This procedure was repeated every ten minutes. After the third measurement series, the test subjects were given 7 dl of a sugar-containing soft drink to drink (approximately 106 gram sugar per liter). The measurements then continued while the blood sugar level increased, peaked and then returned approximately to the initial level.
During this period, the test subjects were free to walk around or use a stationary bike for very light exercise between the measurements. They were then given another 7 dl of soft drink and the measurements continued until the measured blood sugar level had peaked and again showed a negative trend.
The statistical analysis presented in this article was performed using Matlab® 2018b.
Informed consent has been obtained from all individuals included in this study.
The research related to human use has been complied with all relevant national regulations, institutional policies and in accordance with the tenets of the Helsinki Declaration, and has been approved by the authors’ institutional review board or equivalent committee.
Figure 1 shows all the unprocessed NIR spectra for glucose levels below 5.0 mM (blue lines) or above 7.0 mM (red lines) plotted together. From visual inspection, there is no clear separation between the spectra for the two groups.
In figure 2, the real part of the measured electrical impedance, the resistance R, is plotted as a function of frequency. Here also, the curves are color coded with levels below 5.0 mM in blue and above 7.0 mM in red. The reactance X is correspondingly plotted in figure 3. There are no obvious differences between the groups in these plots either, when assessed purely by visual inspection.
In figures 4–8, correlation plots have been made for the impedance and admittance components, namely resistance, reactance, phase angle, conductance and susceptance, respectively. They are all based on Pearson product-moment correlation coefficient calculations. Based on this analysis, susceptance at 455.5 kHz shows the highest correlation of about −0.46. This correlation is not high enough for prediction of blood glucose and hence multivariate models are tested.
Figure 9 shows the results of multivariate partial least squares (PLS) regression, where the models were individually trained until the start of intake of sugar-containing soft drink for the second time and thereafter used for prediction. The model is based on resistance, reactance and NIR reflectance and three components are used. Correspondingly, figure 10 shows a globally trained PLS model with five components, where all individuals are part of the model.
Similarly, figure 11 shows an artificial neural network (ANN) model with the same inputs (R, X, and NIR), which is globally trained until the start of intake of sugar-containing soft drink for the second time and thereafter used for prediction. The ANN has one hidden layer and five nodes, and the Tansig activation function and Levenberg-Marquardt training algorithm were used.
The NIR measurements did not reveal any clear separation in the reflection spectra for blood glucose levels below 5.0 mM and above 7.0 mM. Earlier studies have for example found a mean absolute relative difference (MARD) of 32.7% (see e.g.  for discussion of MARD) when using NIR and temperature to predict blood glucose . Visual inspection of the data presented in figure 1 clearly demonstrates the lack of any meaningful correlation. There could be several reasons for this: The band used by Tronstad
Another difference in the experimental designs was that we removed the NIR probe between each measurement. Although measures were taken to ensure placement of the probe on the same skin site each time, we cannot ignore the possibility that this lead to a higher variance between the measurements that is not related to the glucose level.
The highest correlation for the electrical admittance measurements was found for the suceptance at 455.5 kHz. At that frequency, the measurements will be dominated by deeper, viable tissue and the susceptance will mainly represent the dielectric charging of the cell membranes in the β dispersion range . Hayashi
The PLS and ANN models show that the measured bioimpedance and NIR data are of limited value for prediction of blood glucose level. Individually trained models obviously have the potential to be more closely adapted to each subject and with this design where the glucose level increases in two distinct periods, this should indeed be possible. However, the number of available measurements per subject is very limited in this study. In that sense, the globally trained models have the advantage of a significantly higher number of measurements, but the combined data sets will contain individual variations that may act as noise in the model. In general, a global model would be preferable since it reduces the need for individual calibration.
The possible prediction of blood glucose was tested using NIR and bioimpedance spectroscopy. Although a moderate correlation was found for some of the electrical parameters, it was not sufficient to produce a satisfactory prediction model. The quality of the NIR measurements was probably reduced due to the removal and reattachment of the NIR probe between each measurement.