<abstract xmlns="http://www.w3.org/1999/xhtml">

<p>The article presents steps to be taken when designing a wind turbine with a vertical axis of rotation, based on the modification of the Savonius engine structure. The HP MultiJet Fusion additive manufacturing technology was used and discussed to generate experimental models. The results of numerical and experimental studies of the analyzed geometry of wind turbines, carried out at the Rapid Prototyping Laboratory and the Laboratory of Energy Machines, at the Department of Mechanics and Fundamentals of Machine Design, University of Warmia and Mazury in Olsztyn are presented.</p>
</abstract>

The article presents steps to be taken when designing a wind turbine with a vertical axis of rotation, based on the modification of the Savonius engine structure. The HP MultiJet Fusion additive manufacturing technology was used and discussed to generate experimental models. The results of numerical and experimental studies of the analyzed geometry of wind turbines, carried out at the Rapid Prototyping Laboratory and the Laboratory of Energy Machines, at the Department of Mechanics and Fundamentals of Machine Design, University of Warmia and Mazury in Olsztyn are presented.

Application Use of the HP Multijet Fusion Technology in the Rapid Prototyping of Wind Turbines with a Vertical Axis of Rotation

University of Warmia and Mazury in Olsztyn

Agricultural Engineering

This work is licensed under the Creative Commons Attribution 4.0 International License.

The article presents steps to be taken when designing a wind turbine with a vertical axis of rotation, based on the modification of the Savonius engine...

Application Use of the HP Multijet Fusion Technology in the Rapid Prototyping of Wind Turbines with a Vertical Axis of Rotation

Published Online: Dec 30, 2022

Page range: 253 - 263

Received: Nov 01, 2022

Accepted: Dec 01, 2022

DOI: https://doi.org/10.2478/agriceng-2022-0020

Keywords
wind turbine, Savonius, numerical fluid mechanics, 3D printing, MultiJet Fusion

© 2022 Bartosz Moczulak et al., published by Sciendo

This work is licensed under the Creative Commons Attribution 4.0 International License.

Application Use of the HP Multijet Fusion Technology in the Rapid Prototyping of Wind Turbines with a Vertical Axis of Rotation

Published Online: Dec 30, 2022

Page range: 253 - 263

Received: Nov 01, 2022

Accepted: Dec 01, 2022

DOI: https://doi.org/10.2478/agriceng-2022-0020

Keywordswind turbine, Savonius, numerical fluid mechanics, 3D printing, MultiJet Fusion

© 2022 Bartosz Moczulak et al., published by Sciendo

This work is licensed under the Creative Commons Attribution 4.0 International License.

Keywords
wind turbine, Savonius, numerical fluid mechanics, 3D printing, MultiJet Fusion